Q: I have to run the AC to prevent stalling.

asked by on January 14, 2016

My car is starting to stall, so I am having to run the AC to prevent this. My gas line is cracked somewhere and it is spilling gas. In addition, my car's transmission is acting weird.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Transmission won't go into gear
As bad as that sounds, it could be as simple as a worn bushing which would cause the cable to come loose from the linkage. It may have also been a broken shifter cable. So the first step would be...
Broken Shackle pin and it's effect on drive
This is a question for a diesel trailer mechanic. Without seeing the vehicle, I would not attempt to tell you what is and isn't safe. The old adage, a picture is worth a thousand words definitely applies here. Personally, I...
What are the right plugs and how do i know what I can tweak on the type of plug I use.
Try using the factory plugs first and use them until you get all the modifications done. Then keep checking the plugs every month to see how they are burning to see if you need a hotter plug or a colder...
Serpentine Belt Keeps Breaking and want to know if the Tensioner pulleys could be the cause.
Either the drive belt tensioner (https://www.yourmechanic.com/services/drive-belt-tensioner-replacement) is binding or one of the pulleys (https://www.yourmechanic.com/services/idler-pulley-replacement) are binding. Also, check the accessories for any binding. This is only the way the belt can break. If you still need help, I would have...
Knocking noise - 1997 Oldsmobile 98
Hi! I recommend having a close inspection of the harmonic balancer on the front of the crankshaft. When the rubber that's bonded between the pulley and the hub begins to fail and separate, it starts to move around and can...
Issue is between 3rd and 4th gear during driving.
Hi there. Ford Fusion's are notorious for having transmission issues. In most cases, the problem you are describing has been determined to be caused by an internal hydraulic failure or obstruction. In some cases, it's due to debris inside the...
Can the parking brake be adjusted ?
Hi there. If your Lexus has rear disk brakes, there are two different ways to adjust your brakes. One is to back up about 10 miles per hour and apply the parking brake. The other way is to remove the...
does a 2009 VW New Beetle 2.5 l have a timing belt or a timing chain?
This engine uses a timing belt and not a timing chain.
The hazards come on when i turn either left or right signal switch.
Generally this is something caused by the flasher relay (https://www.yourmechanic.com/services/hazard-turn-signal-flasher-replacement) going bad. This is a small relay that allows the lights to flash based upon current flow and a resistor inside that causes them to flash. When this is faulty,...

Related articles

How Long Does an AC Control Module Last?
Over Over the past decade, vehicles have become far more electronic than they are mechanical, with numerous computers on board that control various functions. Your AC control module is one such computer, and it works to manage the air conditioning...
How Long Does a Cylinder Head Temperature Sensor Last?
The The engine’s performance is largely based on temperature measurements performed by the engine control module (ECM), also known as the vehicle’s computer. As the temperature of the engine increases, the resistance decreases which means the voltage drops. The computer...
How to Replace an Air Conditioning Expansion Valve (Orifice Tube)
Car air conditioning systems need the expansion valve, or orifice tube, replaced if the AC is blowing warm air or the AC system is broken.