Q: I have an 03 350z and it overheated and shut down and started leaking oil and won't start after the over heating

The fan motor turns very fast, and these motors do go bad after continued use; five or six years is a good life span, you made it nine years. I recommend having a mechanic such as one from YourMechanic, inspect...

Te problem most likely exists in the power window motor/regulator assembly if the fuse is good. The fuse should be checked first, and if the fuse is good, the door panel will need to be removed to check the condition...

Check the 20 amp power window circuit breaker in the engine compartment fuse box. If the circuit breaker is sending power to the relay then the main power window switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-power-window-switch) will need to be checked to see if it...

Hello. For your 2009 Saturn Outlook, there is an aftermarket part called a pigtail connector that can be spliced into the existing wiring fairly easily. You may be able to find instructions on the internet that would be able to...

Hello there, thanks for writing in. I would be glad to help you out here. Most likely you have a leak. When the vehicle engine is stone cold, look around the valve cover gasket (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-valve-cover-gasket) for liquid oil and then...

This sounds like you may have a faulty starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. When this fails, it may cause a clicking sound and will...

If the battery is new and fully charged, and you turn the key to the "start" position and you hear nothing that means that either the starter circuit supplying the starter motor (ignition switch, wiring, relay, fuse, etc.) has a...

Hello - removal of the harmonic balancer bolt is counter-clockwise. Be sure to use a flywheel block or pin to prevent counter-clockwise engine rotation, which could cause engine damage. Good luck!

Hi there. In most cases when a fuse continues to pop, it's due to an electrical short somewhere in the system or component in which it is powering. This could be due to a faulty electrical harness connection, exposed wire...