Q: I have a Lincoln SUV it's a 99 my light just came on and when I went to brake today it barely breaks but my Roders and brake pad a

The first issue is you overheated the engine because the cooling fan motor blew the fuse and the radiator split from getting overheated. You replaced the fuse and not the fan and should replace the fan motor also. You replaced...

You can flash the high beams to get someone’s attention, or to alert other drivers. To do so pull the turn signal lever towards you, and then release it. The high beams will flash on and then off, and the...

Unfortunately it looks like there can be a few different reasons as why your Ford Taurus is idling high. Some of these causes for high idling could be a failing Mass Airflow sensor, a faulty Idle Air Control Valve or...

When a horn (https://www.yourmechanic.com/services/horn-replacement) goes off like this, it is usually because something in the steering column has come loose making an electrical connection for the horn. This will require the disassembly of the horn pad to investigate. Often this...

Without hearing or experiencing the noise myself, it is hard to make an accurately diagnose this but GM has a TSB (technical service bulletin) (https://www.yourmechanic.com/article/how-to-use-a-technical-service-bulletin-tsb-to-diagnose-and-repair-a-car-by-valerie-johnston) that may address this concern. There are 3 possible causes from a body mount at...

Hi there: A sputtering engine is typically caused by fuel or ignition system failures. However, there are more than 20 individual parts that could be dirty, faulty or have electrical wiring issues that can contribute to your 2005 Volkswagen engine...

Hello. Most of the time this is caused by a programming issue. I have seen these cars need to be re-programmed for issues with the batteries not fully charging in cold weather. If the vehicles computer have not been updated...

Hi Steven. I wouldn't recommend that method of correcting your 4WD issue on the Explorer. The four wheel drive system works in conjunction together with a center shaft supplying power to the front and rear drive axle, so removing the...

In order for either system to work correctly they depend on the same sensors to work correctly. If one system has a failure then the other system is also disabled and light is turned on. You will need to have...