Q: I have a HHR 2007 the car with lock keeps showing up everything else is coming on don't know what to do

Check fuses for fuel pump, ignition,etc. If they're good, check for actual spark and fuel pressure at the engine. If you don't have both spark and fuel, it will not start. If you have no fuel pressure, then a failed...

The reason "limp mode" has become "unbypassable" is due to the existing codes. The ECT failure (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement), if it exists, may alone account for that because an engine coolant temperature sensor is essentially a master sensor - the value of...

Hi there. The Lucas oil stabilizer should not have caused any issues. The P0019, P0022, P0300, P0305, P0307, and P0308 codes are all related to bank(2). The camshaft position out of sync has, more than likely, led to the misfire...

The Pass-Lock security system can be effected if the battery was disconnected or dead, as well as if something like the ignition switch was replaced. Try these steps below. The Passlock has two basic relearn procedures—a ten-minute procedure and a...

If one air spring will hold pressure and the other will not, there is an air leak in the part of the system that operates the spring that will not hold pressure. The leak can be in the line between...

What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being sent by...

Hi there. Although it is possible that you have an electrical short on a wire heading to the rear or powering the rear blinker, it is more likely that you have an electrical relay or fuse issue. Most wires on...

Claimed by Kevin Gainer

For some reason, our repair database doesn't have the service information listed for your vehicle. However, it does have information for 2013 Beetle 2.0L, which shows the filter should be replaced every 60,000 miles. This interval seems a bit excessive....