Q: I have a 65 Malibu that runs. I just need help with the tuning. Do you have old car guys?

asked by on March 24, 2018

I have a 65 Malibu that I replace the carburetor on it God's would have hit the gas I just want someone to help me that knows what they're doing do you have a guy that works on old cars
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I use the keyless access system to lock the car?
The keyless access system can lock the vehicle for you automatically, so that you don’t have to go through the process of locking your car. After you have turned off your vehicle, your car will figure out how many remote...
Tapping noise at high rpm only.
Hello, thanks for writing in about your Ford E-150. The noise may be the engine is pinging from pre-ignition. This can be due to ignition timing that is too far advanced. Another possibility is that the EGR valve is not...
Transmission shifting
Hi. It's very possible that the source of your problem is related to the transmission control module. In some cases, the sensors inside the transmission will fail to send signals to the TCM and cause the problem you're experiencing. It...
My instrument cluster is not telling me my speed and mileage
It sounds like your speed sensor (https://www.yourmechanic.com/services/speed-sensor-replacement) on the back of the transmission has failed. I would certainly recommend having it professionally tested to verify this diagnosis but this is the most likely cause. If the gauge cluster is still...
When trying to start it only clicks on a large relay (?ECU?) under the dash passenger side.
Often times when there is a starting issue, there is a small part called a starter relay (https://www.yourmechanic.com/services/starter-relay-replacement) that is many times over looked that is usually a fairly simple and inexpensive fix. The starter relay is a small unit...
Grinding noise when steering left or right.
This is a common symptom of failing wheel bearings. A wheel bearing will usually fail due to pitting or small damage on the surface of the rollers or the bearing race. Both the surface of the rollers and the race...
4Runner has no power in the engine.
Check the engine for a vacuum leak and see if the valve on the brake booster is leaking. Also check the EGR (Exhaust Gas Recirculation) is stuck on all the time. A vacuum leak or the EGR being stuck on...
03 Silverado no crank no start with new starter, new battery, strange weak electrical noise coming from dash when trying to start
What you are describing is obviously an electrical fault and thus will require a circuit trace, of at least the starting circuit, to resolve. Typically, this requires the factory wiring diagram from the service manual. If you want the required...
Oil
Hi Patel. Thanks for asking this question. When it comes to choosing oils, the best oil to use across the board for any vehicle is the one that the manufacturer recommends for that particular vehicle. Inside your owner manual, you'll...

Related articles

A Buyer’s Guide to the 2012 Chevrolet Volt
Whether Whether you’re concerned about the environment or just want a vehicle that allows you to use less gas, the 2012 Chevrolet Volt might be just right for you. Designed to run entirely via an electric current, this electric hybrid...
The Best Used Cars to Buy If You’re an Electrician
As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...
Chevrolet Certified Pre-Owned (CPO) Car Program
Drivers Drivers who are in the market for a used Chevrolet vehicle may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on...