Q: i have a 2013 Chrysler 200 and the back rotors wont come off. its loose but wont come off. not sure what the deal is.
I changed my front brakes and rotors with no problem. not i got to the back ones and got the tire off and got the pads off but cant get the rotor off. its loose but feels like its being held on by something. cant seem to figure it out.
My car has 55000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car won't start; just clicks
Hi. A clicking noise when trying to start your car and no engine movement typically means that the battery is too low to crank the engine or there may be a bad connection at the battery. If the battery and...
Alarm preventing battery installation
Yes, this can be an issue with the Tundra. You should be able to hook up the battery and hit the unlock button and then start the truck to reset the the alarm. The alarm also should reset itself after...
Key won't come out of the ignition, clicking sound while pressing brakes
The most common cause of this is a failing ignition switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-switch). For the ignition switch to allow the key to turn, it looks for the car to be in Park or Neutral. When the car isn't in either of...
Sluggish acceleration issues on 2005 Ford Escape XLT
Hi there. Any number of concerns can create a loss of power. Assuming, the check engine light is not coming on, this leads me to believe the PCM (powertrain control module)/computer is not recognizing the fault. A plugged catalytic converter...
Car starts sometimes for a few seconds. Car ran completely out of gas. I changed the fuel filter, and change battery in the remote.
Hi there. The fuel pressure needs to be checked on the fuel rail. There should be at least 30 psi on the fuel rail. If the fuel pressure is good, then there could be air in the fuel rail causing...
replace right front axel boots assembly 2007 lexus es 350
The relevant repair service to request is CV axle replacement (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). Due to the labor involved in removing the joint, disassembling and cleaning it, and re-greasing the joint, it is actually cheaper to replace the entire axle as a unit....
screw edge of sidewall
Hi there. The general policy on repairing tires with a screw or nail, is that the puncture needs to be contained within the tread of the tire, up to 1/2" from the sidewall. Due to this fact, when there is...
I turn my car on it runs then turns off
You will need to have the fuel pressure tested to see if the pump stopped working or the fuel you put in contaminated the system and is not good enough to fire the engine. If you have spark and fuel...
When i reverse out of my driveway then shift into drive sometimes it doesnt shift into drive
Have the shift cable checked to see if it has worn cable ends and check to see if the fluid is low. If you check both of these and they are okay then you will need to have a mechanic...
Related articles
Top 10 Brake System Issues Every Car Owner Needs To Know
Every driver should know how to check for problems with car brakes. Warped rotors, leaky brake hoses, and squeaky brakes are among the most common.
The Best Used Cars to Buy If You’re a Vet
The The best car for a vet to own largely depends on the type of practice he or she has. Large animal vets are probably going to want something that delivers a fair bit of power, and possibly even towing...
How to Diagnose and Repair Noisy Brakes
Squeaky car brakes are hard to drive with. If your car brakes are making noise, check the brake pads and brake rotors to see if they are worn down.
Browse other content
Cities
Maintenance