Q: I have a 2011 silverado i cant put gas into the tank and tve fuel gauge is reading full with an empty tank

asked by on November 13, 2017

I went to fill up at the station the other day It only took a little but if gas before overflowing and couldn't put an more gas in. When I started the truck the gauge read full on an empty tank and still can't fill it up because it overflows. I disconnent the charcoal filter and blew it out and disconnented the vent tube and tried to fill it up no luck.

My car has 150000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I install a child seat?
It’s vital that you have your child in the right type of car seat for his or her age, height and weight. However, it’s also essential that you have the car seat secured properly in the back seat. Here’s what...
Transmission leaking
With the fill plug chewed up, you will not be able to check the fluid quality or level in your gearbox. You will need to have a technician equipped with an extractor to remove the plug, check fluid level and...
Losing coolant on a 2003 Dodge Ram 1500
If it's been pressure tested it shows no leaks, the odds are that it's burning. In your case, it's almost always a head gasket that is starting to blow. I've got a video called "How to Tell If Your Head...
Rattling noise rpm jump
Hello there. It sounds like there may be a few things going on. The noise could be a number of things, such as the belt idler, engine misfire, injectors (https://www.yourmechanic.com/services/fuel-injector-replacement), engine mechanical damage, or the turbo. A rattling noise is...
I need to know what size exhaust gasket to get
Hi there, thanks for writing in. If your new exhaust is cat back, then you will have the factory flange on the back of your catalyst. I recommend just getting the same size as the factory one you removed.
Do I need to repair or replace my ECM?
You can get an ECM-related code for a number of different reasons. It can be something as simple as a voltage loss from a bad battery connection, or it may need a new ECM. I usually check the codes and...
Loud exhaust
Hello. The symptoms and situation that you describe are commonly associated with an exhaust leak. If your muffler or exhaust pipes were bent when the accident occurred then it is very possible that they developed an exhaust leak and are...
No fire motor turns over. Changed ignition coil crank shaft position sensor and idol air control sensor
Hello, thank you for writing in. The vehicle may be having one of several issues. If you have a slow crank, then the engine is not able to start because the starter is not going fast enough. Next you will...
2003 jeep grand cherokee ac low side pressure too high changed expansion valve, dryer and compressor no change
Hello, thank you for writing in. With the amount of work done on the air conditioning system up to this point, you may have introduced air into the system. Make sure the refrigerant is properly cycled out and recharged, rather...

Related articles

A Buyer’s Guide to the 2012 Chevrolet Avalanche
Few Few vehicles are as distinctive as the Chevrolet Avalanche. Part SUV, part truck, the Avalanche is actually surprisingly practical. On the inside, it feels more like a Chevy Tahoe, except when you look out your rearview mirror, you’ll notice...
A Buyer’s Guide to the 2011 Mazda RX-8
The The 2011 Mazda RX-8 is a sporty, two-door coupe that is able to seat four people (two in the front and two in the rear). While this was the final year of production for the RX-8, it definitely made...
The Best Used Cars to Buy If You're a General Contractor
If If you're a general contractor, you probably aren’t in the market for a used car. More likely, you’re looking for a pickup truck, because you need to haul equipment and supplies to various job sites. Most contractors will likely...