Q: I have a 2011 Chevy Aveo that majority of the time will only start in neutral

Hello. It is not normal for your clutch to have problems after being replaced a year ago. The cause of this is most likely due to a failure of the slave cylinder. There are other less common causes for the...

Hello. We will be very happy to assist you with your 2005 BMW 330xi. Your description sounds like that of a broken ball joint (https://www.yourmechanic.com/services/ball-joint-front-replacement) or constant velocity axle (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). Especially being that the wheel had a feeling like it was...

Hello. Most of the time if the vehicle is running fine and the lights just came on then you more than likely have low brake fluid. If the fluid level is low then all of these lights will come on....

Hello. If you are experiencing repeated failure of brand new pumps from the same manufacturer, then it may be possible that you are simply running into low quality parts. I would inquire with the seller of the pumps if they've...

Hi there. The best way to diagnose any problems with the front end is to have a professional mechanic take a test drive. However, the symptoms you are describing are similar in many ways to worn out brake pads (https://www.yourmechanic.com/article/symptoms-of-bad-or-failing-brake-pads)....

Hi there. From the description you have provided, a lot has been done to overcome your vehicle's engine misfire issue. Due to the many possibilities, that can cause a cylinder misfire (ie; spark plug, ignition coil, fuel injector, vacuum leak,...

Hi there. Check the air control flap for if its tight or sticking. Also look at the hose connections to the air control flap. Check the intake manifold air control actuator and the intake manifold air control solenoid to see...

Hi - since the repair history, and the on-going brake problem symptoms (https://www.yourmechanic.com/question/my-brake-pedal-s-soft-and-the-car-s-braking-system-is-in-good-shape-so-what-can-it-be-by-mike-m) seem a bit murky, I would recommend a brake system inspection (https://www.yourmechanic.com/services/brake-safety-inspection) by a mobile, professional mechanic, such as one from YourMechanic, who will come to your...

You need to make sure the engine is getting up to operating temperature in order to get full heat out of the heater core your engine needs to be up to operating temperature. If the engine is not then your...