Q: i have a 2008 buick enclave my car has the bucking and stalling what should be done

Hi there. If your car has overheated, it may have caused your head gasket to warp. This warpage allows coolant to enter combustion chambers causing your vehicle to not efficiently cool. An external leak is not necessary for this blown...

With the symptoms you have described, the most likely cause is a leak in the transmission. When the fluid level changes drastically, the transmission loses the ability to pump fluid and transfer power. A qualified technician, such as one from...

The source of the leak will need to be determined. The pump itself, the hoses, or the rack and pinion are all suspect. Once repaired and fluid is added, the wheel should be easy to turn. If you would like...

The P1682 code means that there is a difference in voltage between the ignition switch circuit 1 and circuit 2. There are a few things that can cause this - including a fault with the ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement) itself or...

Hi, thanks for writing in. This is a common sign of a failing mass air flow sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-mass-airflow-sensor). This is a unit that regulates the air flow (https://www.yourmechanic.com/article/what-does-the-mass-airflow-sensor-do) into the engine as it is mixed with fuel prior to being...

Hello, thank you for writing in. The vehicle will illuminate the reduced engine power warning light (https://www.yourmechanic.com/services/warning-light-is-on-inspection) for many reasons. The throttle, a number of sensors, poor ignition, and many other factors can turn it on. If you have not...

Your Mechanic does not provide any type of paint or body repairs. Unfortunately we could not give you a cost on painting shocks or calipers. Vehicle ride height has little to do with shocks, calipers, or any other part developing...

You may want to check the voltage to the alternator. If you have a voltage regulator that i allowing the alternator to produce too much amperage, this may cause the alternator to produce too much amperage resulting in a burning...

The part that is covering the oxygen sensor is the heat shield on the exhaust manifold. You will have to remove the heat shield first to get the O2 sensor off. If you need further assistance with removing the heat...