Q: I have a 2003 Nissan sentra and it takes a while for it to accelerate properly.

asked by on April 04, 2017

My car takes a few moments before it accelerates and my check engine light has came on. It hasn't done it before it just started today. What could possibly be the cause of it?

My car has 187934 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Power steering hard to turn
Although you added fluid, did you check to see that the level was in the appropriate mark for what the temperature the engine is (cold/hot)? If so, its likely that the pump bearing has failed and which means the unit...
Changed VANOS Solinoid-Mechanic Wants to Replace Entire Engine
It's entirely possible that there is an engine problem. The VANOS system is BMW's take on variable valve timing, and if your car is a regular Mini Cooper, not the Cooper S model, then it has double VANOS and uses...
Why when i go to crank up my car i have to press the gas
If you have to hold the gas open to start then you may have a throttle body (https://www.yourmechanic.com/services/throttle-body-replacement) and idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) that has carbon deposits that need to be cleaned. The intake valves may also have carbon...
A/C fuse busted when car starts to run
Hello there, thank you for asking about your 2004 Honda Civic. You should try to disconnect the AC compressor and run the car as if the AC compressor is plugged in to see if the fuse blows still. If it...
Why is my steering wheel always locking and upside down exclamation point ?
Your steering wheel is supposed to lock when you turn off the car off. You cannot disable it. If you first straighten the steering wheel straight ahead before you turn it off then the steering wheel will not bind on...
Air conditioner not working after a battery change
Hello. Thank you for writing in. At first, disconnect the battery and verify that all of the wires in the starting system and charging system are clean, dry, and tight. Make sure the battery cables are corrosion free, and have...
Would a click, click sound (battery 100% charged) mean a bad starter solenoid, or bad alternator?
Hello. We will be happy to assist you. The issue your vehicle is having may be caused by faulty wiring such as corroded battery to starter wiring or a loose battery terminal. The most likely causes are a bad starter...
Should I buy a car if the person lost the keys?
Hi There, Depending on the type of vehicle, this may be a bit expensive to have the vehicle either re-keyed or have new key fobs purchased and re-flashed to the car's computer You may also want to consider having a...
Front wheel of truck won't move and making grinding noise
If you had your brakes removed and hub will not turn freely then it is the bearing in the hub. I would recommend replacing both front hub bearings since they both have equal amount of wear and the other side...

Related articles

P2263 OBD-II Trouble Code: Turbo/Supercharger Boost System Performance
Diagnostic Diagnostic Trouble Code (DTC): P2263 P2263 code definition Turbo/Supercharger Boost System Performance Related Trouble Codes: P0039: Turbo/Supercharger Bypass Valve Ctrl Circ Range/Perf...
P2453 OBD-II Trouble Code: Particulate Matter Trap Differential Pressure Sensor Signal Performance
P2453 P2453 code definition Particulate Matter Trap Differential Pressure Sensor Signal Performance What the P2453 code means This trouble code will only appear on diesel engines and it indicates that the powertrain control module has detected a voltage reading from...
P2014 OBD-II Trouble Code: Intake Manifold Runner Pos Sensor/Switch Circuit Bank 1
P2014 means there is an issue with the intake manifold runner control system which is usually associated with a faulty control solenoid.