Q: I have a 2003 Chevy Impala
I have a 2003 Chevy Impala, LS(just trim and 3.1 Liter). Went to replace front stabilizer bar and bolt on right front that goes into the sub frame that is sealed. Bolt just spins. HELP. What can I do? Can I cut a SMALL hole into side of frame to get wrench in to put new bolt and nut in?
Larry Garcia 630-536-9490 larrygarcia2002@gmail.com
My car has 131900 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
There’s a big lag with the throttle
Hello, being a drivability issue it will require some diagnosis with a technician. If you can demonstrate it to the technician it would aid in diagnosis. It sounds like you might have low fluid level based on how you say...
What is the vehicle stability assist?
Your car has a stability assist system built into it (VSA). You might be more familiar with this as “electronic stability control,” but they both refer to the same thing. The VSA is a system designed to enhance stability and...
Can't pass smog check due to Check Engine light
The Check Engine light requires a special scan tool to determine the issue. Additional diagnostics may be required. An intake leak is common on this engine and may cause leaks, low fluids, and many other issues. With the vehicle sitting...
Something dragging underneath car
Hello, your car has what is called splash shields. They are attached to the bumper and cover the oil pan and transmission. Often, the plastic clips come loose or break, causing the splash shield to hang down. The splash shield...
When in reverse, jumpy acceleration; power loss when in reverse, vibrations when idles, exhaust sounds irratic
The ignition system has more than just spark plugs, and some of the other parts, like the plug boots or the coils, are causing the misfire and running rough. I would remove and inspect the plug boots and coils for...
Car is shaking at 60 MPH 60
Control arms and control arm bushings are a very common failure on your car. If there is even a slight imbalance in the tires and wheels, the effect will be greatly amplified by any looseness in the front suspension.The control...
When i drive the car's dash indicator for the Hot-Cold after 10 mins of driving goes to the hot setting ? Where should I start?
The most common causes of overheating include low coolant level, a faulty thermostat, a plugged radiator, collapsed hoses, non functioning cooling fans, and a faulty water pump or drive belt. Certain engine faults, such as a leaking head gasket or...
My BMW 335i n54 coolant line hose o ring needed to replaced. I think coolant is leaking from there.
The best thing to do is get a coolant pressure test and hook it up to your radiator or reservoir and pressurize the system to 15 psi. If there is a leak, it will appear under a pressure. If you...
Related articles
The Best Used Cars to Buy If You Love Road Trips
If If you love to travel, comfort is very important in a vehicle. You want a nice, quiet ride, comfortable seating, and enough room. We have evaluated several used vehicles, and narrowed our favorite road trip vehicles down to the...
The Best Used Cars to Buy If You’re an Electrician
As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...
Chevrolet Certified Pre-Owned (CPO) Car Program
Drivers Drivers who are in the market for a used Chevrolet vehicle may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on...
Browse other content
Estimates
Services