Q: I have a 1981 ford f250 it stalles when I let off the gas and it has a new fuel pump and filter

Your car offers convenient storage solutions in a number of places, from the trunk to the center console. You also have an instrument panel storage compartment. It’s located above the air vents in the dash. Here’s what you should know:...

Hello! I have not come across this issue specifically related to BMW's. However, what jumped out at me was the fact that two BMW dealership service departments aligned your 740i, took your money, and sent you away with a very...

As far as the power window fuse, there is obviously a shorted circuit causing the fuse to pop every time. The components of the system must be inspected by an automotive electrical technician to track down the fault. The stalling...

Hello. In order to determine if the transmission needs to be replaced, a proper diagnosis would be required. Even if the whining noise sounds similar to that in the video, it can still be possible that the issue is caused...

Hi, thanks for writing in. This is a known issue in the Ford F150 that is usually caused by the steering column control module going bad (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-power-steering-control-unit). This is what controls this and can be purchased for around $60. If...

I don't think it has to do with your speedometer. The speedometer cable that goes to your speedometer has a sensor on the opposite side but the sensor isn't big enough to cause damage to your transmission. I would check...

This may be a result of a faulty oxygen sensor reading as a result of your exhaust system (presumably your catalytic converter) not operating effectively. As you may know the oxygen sensors which are part of your emissions system read...

This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, making turns (which makes use of the power steering pressure switch) turning on...

Engine heat can degrade components such as ignition coils and the crankshaft position sensor. The components will then fail once they are hot. There are other possible causes of the stalling, too, such as the fuel pump relay opening or...