Q: I had a low oil pressure reading and when I shut the car off to pump gas and tried to turn it back on it did nothing. It wouldn't

The best thing to do is to have your cooling system checked to find the cause of the broken tube. The system may have other issues that would need addressed at the same time. That being the case, I recommend...

The EWS (Electronic Immobilizer) light on your BMW is an alarm that will cause your car to not start. Something you can attempt is using a different key to start your BMW. If after trying a different key, the car...

Does the vehicle start and or run? When several systems are effected it is likely a wiring issue. You may be experiencing failure of the fuse box panel, or major electrical ground somewhere. If you own a voltmeter, you can...

Hello. You can replace the air suspension components with traditional suspension components, however doing so would remove the air functionality of the components. If there is a compressor on the vehicle it is likely that it generates air pressure for...

Hello - your symptoms suggest a worn front wheel bearing (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-wheel-bearing-gone). The "steering is a bit loose" symptom reinforces this diagnosis. If the noise ceases when turn left, it is likely the left wheel bearing. It would be the right...

The software update that was performed on your vehicle maybe for a vehicle with a different transmission. Check the version of software that was installed in your car and verify what model that it refers to for your transmission.

Hi there - I think your question has to do with the engine "jumping time" - that is the timing chain has jumped a cog or three on one of the sprockets, and engine management realizes one or both camshafts...

Hi there. This issue could be caused by multiple system or component failures, ranging from fuel system parts or ignition system component failure. It's probably a good idea to have a professional mobile mechanic come to your location to complete...

Hello Typically when this occurs it is due to the brake fluid being contaminated or from a failure in the brake master cylinder. Most of the time when something other than brake fluid is put in the system the seals...