Q: I had a check engine light and it came out for the same reason of post catalysts fuel from system bank 1 lean is their warranty?

Each of these codes are for different problems, and would need to be diagnosed. If you are low on coolant, then your misfire may be due to a blown head gasket and the first three codes. The last code, P0768...

Hello. A click noise when the engine is started is usually attributed to a bad battery (https://www.yourmechanic.com/services/battery-replacement) or connection (https://www.yourmechanic.com/services/battery-cable-replacement). If the battery was recently replaced, I would make sure that it is adequately charged, and that the battery terminals...

There are several components that can cause this problem. You are correct in thinking one could be the ignition system. Heat from the environment or the engine will cause the coils to expand, and not allow for the connection to...

Hi there. Diagnoses needs to be performed. As you already know, replacing components can be expensive and time consuming without resolution. The P0032 (https://www.yourmechanic.com/article/p0032-obd-ii-trouble-code-ho2s-heater-control-circuit-high-bank-1-sensor-1-by-john-nelson) and P0038 codes could be the result of a blown fuse (https://www.yourmechanic.com/services/fuse-replacement), a wiring issue from...

Hello. Thanks for writing in. When it comes to situations like this, always keep it simple. Seeing that the steering is the only issue contribution factor, its likely the pump is going bad. The power steering pump uses engine power...

Hello. Replacing a timing belt for that particular model of vehicle only requires that the passenger wheel be removed to access the lower part of the engine. This can be done with a regular jack and jackstands. The procedure itself...

Hi there. The first thing that I recommend doing is check for any codes that the engine may have stored. The ECM may have the engine management system shut down for an issue with the traction control system malfunctioning. Perform...

Hi There, Code P2006 relates to the intake manifold runner control which operates the opening and closing of that particular intake runner. This is powered by an electronic actuator which sometimes becomes faulty or can have a bad connection. When...

The ticking noise may be from the valve train. Whenever there is inadequate oil in an engine, the valve train may run dry and that will cause noise. If damage occurs due to that lack of oil, the noise could...