Q: I changed the throttle gasket in my 2010 Mazda 3 and now the engine revs high when started. Is there something that needs adjusted
I changed the throttle gasket in my 2010 Mazda 3 and now the engine revs high when started. Is there something that needs adjusted?
My car has 120000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
What is the recommended tire pressure during high speed driving?
First off, Honda does not recommend driving faster than the speed limit at any time, unless you’re part of a sanctioned (licensed and legal) event. If you do intend to put the pedal to the metal in such an event,...
How do I change the language?
You can choose what language you would like your vehicle’s display to be in with just a few steps: 1. Press the Trip Computer switch until the settings menu shows up. 2. Rotate the Trip Computer switch to Language, then...
Car overheats
This is a very broad question with little information to go on. The most common causes of overheating are low coolant or the engine cooling fan clutch since your car has a mechanical fan. More information would be required to...
Need to pass smog test
The AC on this car is known to have failures from the compressor such as leaking lines, control module problems, and evaporator issues; there are too many possibilities to give a good diagnosis without checking it first. The smog test...
what causes a P0174 bank2 combustion too lean
You will need to have the system inspected thoroughly to see why the vehicle is going lean. The possible causes are that you are loosing fuel pressure or fuel volume. If fuel pressure gets too low it will cause the...
Is it possible to remove Bracket bolts without removing caliper pins?
The complete bracket and caliper can be removed this way. I have seen this many times where the caliper retainer slide bolt seizes. The reason is no one lubed the slides and pins when they did the brakes in the...
Audi A3 2001 1.6L - Overheats and goes back to normal
This is a sign of a faulty coolant fan relay switch. When this is not working properly, this can cause the fans to come on intermittently, or sometimes stay on all the time or not come on at all. When...
Car will not start - 2006 Volvo S40
Hi and thanks for your question. There are three things that could cause this situation. Your vehicle could have a failed starter, a failed fuel pressure regulator, or a break in the wire from the ignition switch to the starter...
Gas gauge stays at full was fine until I replaced the fuel pump/sending unit
Since you took the fuel pump and sender from another vehicle then it most likely needs a new fuel sending unit. The sending unit is most likely corroded from sitting in an empty tank for who knows how long. You...
Related articles
A Buyer’s Guide to the 2013 Mazda CX-5
Key Key Features The Mazda CX-5 has a 2.0 liter four cylinder engine that offers 155 hp at 6,000 rpm. The fuel economy is estimated at 26 mpg in the city and 35 mpg on the highway for the front-wheel...
2012 Mazda CX-5 vs. 2012 Toyota RAV4: Which One Should I Buy?
Mid-size crossover SUVs are an excellent option when you need to take several friends along with you, or bring your kids along and yet still need to keep a tight leash on your purchase cost as well as your ongoing...
The Best Used Cars to Buy for Long Commutes
Most Most of us are faced with the prospect of commuting back and forth to work on a daily basis, but some have a much longer drive than others. When it comes time to buy a car, you need to...
Browse other content
Estimates
Maintenance