Q: I changed my slave cylinder and master cylinder, I also changed the hydraulic fluid line, and put a new clutch about 6 months ago.

An aftermarket exhaust system (https://www.yourmechanic.com/article/what-are-the-benefits-of-an-aftermarket-exhaust-system) MAY be of some benefit to your vehicle. One of the most restrictive and power-robbing systems on cars today is the exhaust system. Having a free-flowing exhaust system and being able to get all of...

Hello. I suggest that a technician inspect the following things. First the transmission fluid level should be checked. Low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) could cause a vehicle jerk. Also, the condition of the wheel bearings (https://www.yourmechanic.com/services/wheel-bearings-replacement) and CV axles (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement) should be...

OBD-II came out in late 1995 in some vehicles, and all vehicles from 1996 onwards. You may need to try an OBD-1 scan tool or try to obtain the codes another way. It is also possible that you have some...

Disconnecting the battery will not clear any codes in memory of the computer for stored OBD2 codes. The only way to clear the codes (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is to use a scanner and use the code clear function.

Drain the coolant a little to lower coolant level below thermostat housing. Remove throttle inlet tube for access to thermostat housing under throttle body. Remove upper hose and heater hoses from housing. Remove housing bolts and replace thermostat. Reinstall components...

You didn't say weather you had a "rough landing." If in the process of spinning you ran over some debris or maybe a curb, you could have damaged your oil pan and lost your oil. If you haven't already looked...

You have had a failure in the anti theft system and would need to have the system scanned for codes to see if a component has failed in the system or the theft module has failed. The module is most...

Hi - finding coolant leaks (https://www.yourmechanic.com/question/leak-in-my-cooling-system-by-kalah-w) like this requires a careful eye. Tight engine packaging, and the fact that slow leaks can evaporate quickly, make it more difficult to determine the source of the leak. A leaking hose connection at...

Hello there. Typically when an engine runs rough when it's cold, it tends to be due to a problem with the fuel to air ratio not being corrected and fine-tuned by sensors. The OBD-II trouble codes you've posted seem to...