Q: I change the dayco timing component on a 2006 Chevrolet Aveo and naw it won't start what can bee the course

asked by on January 17, 2017

Well on a snowy day I when this to start my car it ran for a little bit but then it completely shut off n when I try to crank it again it won't start it was just making a noise n then that's when I not hive that the dayco timing belt was broken so I replace it n put everything back together but when I when the to start it it just sound like there no power enough to crank it I also change the starter befor I even change the dayco timing belt

My car has 120000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

My truck shakes when I hit the gas
This issue is most commonly caused by the driveline shaft's slip-yoke and splines. It is caused by the two piece driveshaft slip joint binding up when the two shafts slide in and out of each other. This will mainly occur...
Exhaust sound
The exhaust would need to be inspected to determine the cause of the noise; it could be coming from the muffler, or indicate a problem with piping, or the converter. I recommend that you have a mechanic, such as one...
The hood of my car does not stay open
Hello! The hood on your car uses two hydraulic struts that support the hood when it is up. When the struts lose their internal pressure they no longer can hold up the hood. Even if one is bad, the good...
what is the function of this LOCK PLATE , COLLAR NUT, BEARING RACE, SHIM X, output FLANGE?
The output flange is to connect the driveshaft or axle depending on the type of rear end you have. The lock plate holds in the bearing using a shim to pre-load the bearing into the race. The collar nut holds...
Brakes caliper will not grab rotor
Hello and thank you for contacting YourMechanic. Check the caliper (https://www.yourmechanic.com/services/brake-caliper-replacement) for the piston sticking. Remove the pins (bolts that make the caliper a sliding caliper) and put some anti-seize on them and reinstall them. Recheck the brakes to see...
What can cause your car not to catch gear?
Based on your description, the problem could be in the engine, the transmission or both. If transmission related, it could be as simple as a low level of transmission fluid or as complicated as an internal fault in the transmission...
Where is a transmission control solenoid located on a 2008 dodge Durango with a 4.7
The transmission shift control solenoids are located in the transmission valve body which is accessible once you remove the transmission oil pan. Typically, transmission valve bodies, and the solenoids, can be serviced without removing the transmission from the vehicle. There...

Related articles

Can a Car Battery Freeze?
Cold temperatures can make it hard to start your car, and extreme cold can freeze a battery. Use a battery heater to make your car reliable in winter.
How Long Should a Car Battery Last?
Eventually your car battery will become worn out and need to be replaced. Most car batteries should last about six years if well taken care of.
The Top 5 Selling Cars in Alabama in 2012
2012 2012 was a great year in Alabama for auto manufacturing, but that wasn’t the only bright spot. Vehicle sales in Alabama were also robust in 2012. Nothing much changed in terms of the vehicle types that were most popular...