Q: I cannot locate the solenoid vent valve in my car.
I cannot locate the solenoid vent valve in my car. All the diagrams and videos I have found look completely different than what's under my hood. I also checked drivers manual and was unsuccessful at finding the location Any idea where it would be. Also I replaced my MAP sensor and when I put in the new part it did not click in like the old part, and when I started call and gave it gas it stalled, so I had to put old one back on. Any idea why this would be?
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do you operate the windshield wipers?
Your car’s wipers provide you with the ability to see clearly out the windshield during inclement weather, as well as to operate the windshield washer system to clean the glass. Here’s how to use them: The ignition must be on....
car keys getting hung up in the ignition
You cannot buy regular keys and key cylinders to replace the code key set you have now. You can check to see if you can purchase the code key ignition set aftermarket, but I would only recommend the dealer part....
I have and evap leak. I don't know where.
If your vehicle has an EVAP system leak, the Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) will normally illuminate, because a Diagnostic Trouble Code has been stored, and the Mechanic can use the Code that was stored to start his or her Diagnosis....
Check engine light & caution light is on? What is wrong?
Hello there, a few common faults will cause your 2003 Acura CL to overheat and have the check engine light illuminated. Without knowing what codes your vehicle is displaying I can only offer general advice. The thermostat and gasket are...
My car loses power while I am trying to accelerate. It will not reach the next gear.
Hello. With the amount of information, there are a limited number of suggestions. These include loss of ignition with higher spark loads (weak coils or ignition module), inadequate fuel supply -quantity and pressure (weak fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement), clogged fuel filter...
Should I purchase.
Hi there: As the owner of a 2008 BMW 128i convertible with 100,000 miles, I understand some of the benefits of having that type of 'weekend cruiser' in the garage. In general, BMW's have a few common issues that tend...
Check engine light and stalling
Hello. The symptoms you describe can be caused by many things. An issue with the engine management, fuel, or ignition systems can all cause performance issues, and if serious enough, stalling. Anything ranging from a bad engine management sensor, to...
Reduced Power Light
Hello, thank you for writing in. The Reduced Power Warning Light will illuminate for several reasons. If the engine's computer detects an issue that can be detrimental to the engine, it will automatically reduce the power to make sure no...
04 Nissan car starts to overheat consistently at around 14-17km distance even after having the water pump and radiator replaced.
Hi there. If the vehicle does not have a thermostat, it needs to have one installed. The cooling system, including the water pump and radiator is virtually useless unless the thermostat opens the radiator to allow coolant to flow through...
Related articles
A Buyer’s Guide to the 2012 Hyundai Sonata Hybrid
When When Toyota first introduced the Prius, the idea seemed to be that all hybrids and electric cars had to have their own specific models and that they couldn’t look like normal cars. A lot of consumers weren’t too thrilled...
Symptoms of a Bad or Failing Canister Purge Solenoid
Common signs of a problem with a car EVAP canister purge solenoid include rough idle, difficulty starting, and the Check Engine Light turning on.
How to Replace a Canister Purge Solenoid
The canister purge solenoid prevents harmful vapor from releasing into the atmosphere. A faulty solenoid will not allow you to pass an emissions test.
Browse other content
Maintenance
Estimates