Q: I can't keep fuel from ejecting out of disconnected fuel line.

If your car is making a clunking or rumbling noise, I suspect that perhaps a wheel bearing or CV axle has failed. However, it would be hard to properly diagnose this issue without an in-person inspection. I would recommend having...

If the brake caliper is sticking due to the piston binding in the caliper then it should be replaced. Raise and support the vehicle, remove the tire, and disconnect the brake line attached to the caliper. Remove the caliper attachment...

Hi there: In most cases a grinding noise is caused by lack of lubrication or metal-to-metal contact. It's commonly a sign of damage to wheel bearings, or suspension components. The best way to correctly diagnose this issue is to have...

Hi there. The codes you provided are commonly related to the EGR or Exhaust Gas Recirculation system; specifically the EGR valve or solenoid. You may want to read this article (https://www.yourmechanic.com/article/p0404-obd-ii-trouble-code-exhaust-gas-recirculation-circuit-range-performance-by-jay-safford) on what typically triggers these codes and possible solutions....

There could be a number of different things causing this issue. There could be issues with your suspension, engine, transmission, or axles. In this case, I would strongly recommend having a full vehicle inspection performed by a qualified professional. This...

Hello. Depending on what is wrong with the compressor will determine if it can be driven with it. If the compressor is simply not functioning and cooling the vehicle then you would be fine to drive it. If the pulley...

There is a fuse box below and to the left side of the steering column. That fuse box is covered by an access door that is part of the dash. In addition, there is a fuse box in the engine...

A few different things will usually cause the vehicle to start and then die (https://www.yourmechanic.com/services/car-starts-and-then-dies-inspection). A bad ignition coil (https://www.yourmechanic.com/services/ignition-coil-replacement) can cause this if it is beginning to fail, resulting in intermittent starting problems. A dirty or faulty mass air...

If the oil filter gasket (https://www.yourmechanic.com/services/oil-filter-housing-gasket-replacement) does not properly seal, this may result in oil leaking out. Depending on the severity of this and how quickly it leaks, this may result in the motor running dangerously low on oil which...