Exception in rendering!

Message: window is not defined

ReferenceError: window is not defined
    at new c (/tmp/execjs20161208-18535-1knx49hjs:136:3912)
    at m.mountComponent (/tmp/execjs20161208-18535-1knx49hjs:47:15602)
    at /tmp/execjs20161208-18535-1knx49hjs:49:31860
    at a.r.perform (/tmp/execjs20161208-18535-1knx49hjs:47:12503)
    at Object.a [as renderToString] (/tmp/execjs20161208-18535-1knx49hjs:49:31821)
    at r (/tmp/execjs20161208-18535-1knx49hjs:50:21164)
    at Object.S.ReactOnRails.serverRenderReactComponent (/tmp/execjs20161208-18535-1knx49hjs:32:6073)
    at eval (eval at <anonymous> (/tmp/execjs20161208-18535-1knx49hjs:173:8), <anonymous>:10:23)
    at eval (eval at <anonymous> (/tmp/execjs20161208-18535-1knx49hjs:173:8), <anonymous>:17:3)
    at /tmp/execjs20161208-18535-1knx49hjs:173:8

Q: I can't disconnect my oil coolant lines from under my truck

asked by on

It won't come disconnected

My car has 214000 miles.
My car has an automatic transmission.

A: Hey there. There are a variety of reasons t...

Hey there. There are a variety of reasons this may happen. Sometimes when the lines are corroded or rusty, the fittings on the end are very difficult to break loose. Try spraying some WD40 on the ends of the fittings and letting it sit for a few minutes to try and break them loose.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Won't start after hit

It sounds like your fuel pump has failed. This was most likely caused by running out of gas. The fuel is actual what keeps the fuel pump cool. If it overheats, it can burn the contacts out or melt the...

Q: hi after month ago m bmw 325i 2002 lost oil and ia had to add 2 qurts every 500 t0 1000 mile what is the problem

Check for any obvious oil leaks. Given your mileage, a failed rear main crankshaft oil seal is the most likely the cause of this oil consumption. In addition, if any of the crankcase ventilation components (like the PCV) have become...

Q: ABS & Brake Warning Lights combined with Uneven Brake Wear Side v Side

When you look at the brake pads on the right side, if both the inner and outer pads are worn then you have a caliper piston sticking or the brake hose holding pressure to the caliper. To check this...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.