Q: how to get out of car once disconnected because its curvy 2004 cadillac cts 3.6 coolant inlet pipe

It sounds like you may have a fuel pump issue. Often times the fuel pump will operate until the pump motor gets warm and then it will loose contact inside. once it cools down then it will make contact again...

If you would like to delete an entry from your Bluetooth phonebook, you can do so easily, and with just a few steps: 1. Press the Phone Send button. 2. Following the tone, say “Phonebook”. 3. Following the prompt, say...

The timing has jumped. Timing is the most common issue with the engine (https://www.yourmechanic.com/article/how-does-a-timing-chain-work). The timing chain guides and tensioners on these engines have chain guides with teflon plastic parts that start falling apart, which causes the timing chain to...

If both of these features quit working at the same time, you may just have blown a fuse (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse). If neither one of these are related, the problem may be two separate ones. The power locks are controlled by a...

There is technical bulletins for your vehicle using aftermarket (https://www.yourmechanic.com/article/all-about-aftermarket-parts) oil filters. These oil filters (https://www.yourmechanic.com/article/how-do-oil-filters-work) may look like they fit your car model, but do not allow the proper oil flow to the motor and can cause noises and...

It would be difficult to say the oil change caused the problem unless they did not put in oil, or the engine lost all the oil out of a loose drain plug or filter. Other than that, changing the oil...

On the 2006 Navigator, if a professional mechanic is replacing the axle(s), it is assumed to take about 1 hour to replace one axle (i.e., one side) whether it is the rear axle or the front axle. Replacing both axles...

Based on what you described, the only possibility is that the starter relay is faulty. You may have purchased a faulty one somehow. The reason that I say this is because if you eliminate the starter relay from the equation,...

Depending on the cold air intake, you may be affecting the readings from the mass air flow sensor, which may be causing the motor to stumble when pushing for more boost as you describe. The mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement)...