Exception in rendering!

Message: window is not defined

ReferenceError: window is not defined
    at new c (/tmp/execjs20161208-102436-p71wmujs:136:3912)
    at m.mountComponent (/tmp/execjs20161208-102436-p71wmujs:47:15602)
    at /tmp/execjs20161208-102436-p71wmujs:49:31860
    at a.r.perform (/tmp/execjs20161208-102436-p71wmujs:47:12503)
    at Object.a [as renderToString] (/tmp/execjs20161208-102436-p71wmujs:49:31821)
    at r (/tmp/execjs20161208-102436-p71wmujs:50:21164)
    at Object.S.ReactOnRails.serverRenderReactComponent (/tmp/execjs20161208-102436-p71wmujs:32:6073)
    at eval (eval at <anonymous> (/tmp/execjs20161208-102436-p71wmujs:173:8), <anonymous>:10:23)
    at eval (eval at <anonymous> (/tmp/execjs20161208-102436-p71wmujs:173:8), <anonymous>:17:3)
    at /tmp/execjs20161208-102436-p71wmujs:173:8

Q: How to change blower resistor

asked by on

How do I replace blower resistor and where is it on vehicle

My car has 85000 miles.

A: Remove the sound insulation panel located u...

Remove the sound insulation panel located under the right side of the dash, by passenger's footing area. Disconnect connector to blower resistor next to blower motor and remove the two screws. From there you'll be able to remove resistor from the housing. If you run into any issues or would like some help with this job, consider YourMechanic, as a certified technician can come to you and ensure a good replacement of your blower resistor.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Turned off car, but ac blower kept blowing

Hello there, thank you for asking about your 1997 Oldsmobile LSS. Pulling the fuse was a good measure to keep your battery from dying with the fan staying on. There could be a problem with the switch or relay in...

Q: Replacing engine variable timing solenoid.

The aftermarket part may just have a different design than the original. If you have concerns, you would be better off spending the extra money on the part was designed to work with the vehicle originally. You shouldn't have to...

Q: Bad gas mileage

Hello there. A decrease in fuel milage can be attributed to a few different faults. The most common causes are leaking fuel injectors, oxygen sensors, coolant temperature sensors, vacuum leaks or exhaust leaks. A qualified technician, such as one from...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...