Q: How much to put a axle on

You should get your 'no start' inspected (https://www.yourmechanic.com/services/car-is-not-starting-inspection) by a qualified technician. The most common problem on this vehicle for a 'no start' is the fuel pump and filter. The fuel pressure will have to be checked by a certified...

Hello, code P0420 represents right main catalyst deterioration. There can be a few things that need to be checked before replacing parts. The intake system needs to be inspected for vacuum leaks and unmetered air leaks. The exhaust system should...

Hey there, thanks for writing in about your Jeep Wrangler. I would recommend getting it checked before going away on your trip. The misfire code may be a problem with the variable valve system or the ignition system. With this...

Hi there. The slave cylinder is a part that is attached on the side of the transmission to operate the clutch fork. For your vehicle, the slave cylinder is inside the bell housing area. You can bleed the slave cylinder...

Hi there. The best thing to do is get a digital volt meter or test light and check the headlight high beam harness for power and that will tell you which wire is the power wire for the high beam...

Try to hold down the lock button for 5 seconds and while holding it down also press the panic button once. Try this and see if it does the trick? If not then look in the owners manual for remote...

There is a brake light switch on or near the pedal assembly. That switch could have been jarred in such a way that the switch contacts are stuck in the closed (lights always on) position. If that is what has...

Check engine compression and intake vacuum to first rule out possible mechanical problems such as stuck or leaking valves. Among the causes of poor acceleration (https://www.yourmechanic.com/services/car-is-slow-to-accelerate-inspection) are clogged fuel injectors and/or inadequate fuel pressure/volume. When an injector is clogged it...

Hi Chris. Thanks for contacting us today. The crankshaft position sensor is located near the front of your Saturn's motor, near the front crankshaft pulley. It is possible that this is the source of your hard to start issue, however,...