Q: How easy is it to replace the VCT on a 2010 Mazda 5?
Car check engine code is P0012. I already got timing done so the only thing left to fix is the VCT . I was wondering how easy is it to replace myself?
My car has 83000 miles.
My car has an automatic transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Coolant loss due to possible blown gasket.
A pressure test of the cooling system will reveal if the coolant system has a leak (https://www.yourmechanic.com/services/coolant-is-leaking-inspection). If the gauge drops during testing, there is a leak - either internal or external. If the leak is external, it can usually...
Seat belt not working.
More than likely the buckle needs to be replaced. It's unsafe and illegal to drive without a seatbelt, so I suggest you get this fixed as soon as possible. Any qualified mechanical, like one from YourMechanic, can handle this task...
Issues with EVAP system
It is very possible you may have a vacuum leak causing a rough idle and too much air on acceleration causing sputtering and rough running issues. A smoke check of the induction system would be a good idea. Reading the...
How long does it take to replace the compressor bracket
Once the compressor is removed from the bracket, then there is only a couple of bolts that hold the bracket to the engine block. Make sure the compressor rear bracket is tightened or the new bracket will break. The bracket...
engine codes related
Hey there. If the codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) are cleared with a scanner, check to see if they return. Maybe the system was serviced or the battery ground is loose and causing the circuit to break which could cause a lack of...
EGR code and Cylinder number 4 misfire detected.
Hi there. The Exhaust Gas Recirculation (EGR) valve may be the wrong one or the cheap design could be not designed for the emissions requirements for U.S. standards. If the EGR is pulling from cylinder number 4 and after replacing...
Grinding noise during starting
Hi There, I believe you may be on the right track in terms of the starter gear not disengaging from the flywheel quick enough upon start up. This can happen for a couple of reasons. Either the starter solenoid itself...
What would cause a whining noise from the front of the engine in my 2004 Lincoln LS
Hello. A whining noise from the front of your engine can come from a number of things. Most of the time though it is caused by a failure in the power steering pump or low fluid in the pump. I...
I broke a fuel injector plug in, how do I replace it?
Hello, thank you for writing in. The type of repair you need to do is going to depend on what side of the clip you broke. If you broke the fuel injector side, you will have to replace the injector...
Related articles
A Buyer's Guide to the 2012 Mazda CX-9
If If you’re having a hard time picking between a luxury sedan and an SUV, the 2012 Mazda CX-9 is definitely worth a look. It has the exterior of a mid-size SUV, but inside, you’ll find a world of luxury...
A Buyer’s Guide to the 2011 Mazda RX-8
The The 2011 Mazda RX-8 is a sporty, two-door coupe that is able to seat four people (two in the front and two in the rear). While this was the final year of production for the RX-8, it definitely made...
The Best Used Cars to Buy for Occasional Drivers
Not Not everyone relies on their car on a daily basis. Maybe you aren’t the type that deals with a daily commute, and running from here to there constantly. If that’s the case, you may be looking for a car...
Browse other content
Estimates
Maintenance
Services