Skip the auto shop - Our mechanics make house calls

Q: How do I use the turn signals

asked by on

How do I use the turn signals

The turn signals are important safety features that alert your surroundings of your intention to make a turn. To signal a right turn, pull the Turn Signal lever all the way up, until it locks into place. To signal a left turn, push the lever all the way down, until it locks into place. A blinking arrow will flash on the instrument panel to confirm that your turn signal is on. After making the turn, your turn signal lever should resume to its normal position; if it does not, manually pull the lever to the standard position. Tip Not only are turn signals important safety features, but their use is legally required.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Passenger side rear mirror and gas cap

Hello, thanks for writing in. I would recommend buying a replacement gas cap from factory Ford as these are typically engineered much better than many of the aftermarket companies. Regarding your Check Engine Light, you should have this checked at...

Q: 2012 VW Beetle Turbo. Vehicle will not start.

Prior to performing diagnostics be sure you have a fully charged battery that passes a load test. Then, confirm that the engine immobilizer system (security system) is not activated thus preventing the car from starting. Basically, if a fully charged...

Q: Pressure valve cover rings

The pressure you are observing is not a good thing. First off, check to see if the positive crankcase ventilation valve (PCV valve) is clogged up. If it is, then it should be replaced. Also check to see if the...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.