Q: How do I use the safety locks?

Hi, this comes up a lot on this engine. If the coolant level has gone low without an external leaks then you more than likely have a leak in the intake manifold gasket. This would require that the top of...

This fault code is set when the torque converter lock up function does not activate within one to 3 minutes of cruising at least 50 miles per hour. There are several things that can cause this fault, anything from worn...

The first thing to check is the transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-is-leaking-inspection) level. If fluid level is okay, then the most likely problem causing a poor reverse engagement is low fluid pressure in the transmission. This could be caused by a worn...

Hi there. Leak stopper should only be used in emergency situations as it usually causes more problems than it "fixes". It sounds like the leak stopper may have settled in your heater core and is preventing the proper amount of...

Hello. From what you describe it would appear that the aftermarket alarm system may be having an issue. If the alarm has done this since it was installed then it may be possible that it is wired improperly, or that...

Once the car is completely cool, check the coolant level in the radiator. If low, that will cause overheating. If it is low, you might have a leak (https://www.yourmechanic.com/services/coolant-is-leaking-inspection) that should be diagnosed. If the level of coolant is correct...

You should have the check engine light and engine scanned to see if the engine may be running lean due to low fuel pressures or clogged injectors. You should also have the mass airflow sensor cleaned and checked for proper...

Yes, you can replace a wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) that is pressed in, however this usually requires a hydraulic press n order to remove and replace the bearing. Alternatively, you may remove the hub and take it to a machine shop...

You will need to have system scanned for codes first and repair any received codes first. The exhaust pressure sensor may not be reading correctly and would cause the problem you are talking about. Make sure any other codes are...