Q: How do I use the power windows?

The new compressor may have a sticker on it or there may be information within box of the compressor indicating the correct oil type and amount to use. The drier should have one once it's put in. Most new compressors...

Hello and thank you for your question. Perform a fuel pressure test. Even though the fuel is pulsing out of the injectors with the engine cranking the fuel pressure could be too low. The system must have a minimum of...

Good question. I want to go through a few steps with you and hopefully find your problem and save you some time and money. If you find the issue during steps, then ahead and fix that fault and you should...

Hello. The problems you describe with the front system may either be a faulty control switch or faulty vacuum motors for the air blend doors. The problem in the rear is likely the rear heater control valve, which regulates the...

Sent to CS for billing question on how much it will cost to remove carbon buildup on the intake valves.

Hi there. This commonly happens when the door latch assembly breaks. I have seen this often and it takes quite a bit of work to get it open. The door panel needs to be completely removed. in a lot of...

Hello, thank you for writing in. Typically the pop is something breaking or snapping. In your case there is likely a bracket or clip that holds on the fender that has broken or come undone. We must find what is...

You do not have to remove or replace the timing belt in order to replace the water pump.

There are a number of things that may cause the vehicle to go into limp mode such as faulty transmission control components or various engine control components. Typically, when this happens the check engine light will come on triggering some...