Skip the auto shop - Our mechanics make house calls

Q: How do I turn on the headlights?

asked by on

How do I turn on the headlights?

A: The headlights should be used whenever you ...

The headlights should be used whenever you are driving in dark conditions. To turn them on, rotate the light switch (which is located on the end of the turn signal lever), to the headlight on position. When the headlights are turned on, the parking, side marker, license plate, tail, and instrument panel lights will also be turned on.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Noise after the car is turned off, car idles rough - 1973 Nissan 240Z

Hello. It sounds like the starter relay might be bad and is causing the starter to stay on, which is the clicking noise that you are hearing. There could also be a problem with the starter solenoid. The problem you...

Q: Fans not working properly and temperature gauge rising - 2004 Toyota Camry

Hello - there are still a couple of possible sources of this overheating. A weak water pump, or clogged (internally or externally) radiator may not be transferring enough heat out of the engine. Air pockets in the radiator where the...

Q: electrical ( headlights )

It is possible both bulbs are burned out. The low beam filament in each bulb should be tested with an ohmmeter. The bulbs can also be powered off the car to see if both filaments work but be wary of...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...