Q: How do I move the rear outer head restraints?

The EWS (Electronic Immobilizer) light on your BMW is an alarm that will cause your car to not start. Something you can attempt is using a different key to start your BMW. If after trying a different key, the car...

This may be related to a couple of different things. I would recommend checking the idle air control valve/module (https://www.yourmechanic.com/services/idle-control-valve-replacement) which works similar to the MAF sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) in that it regulates air intake as it is mixed with fuel...

Hi - rough running (https://www.yourmechanic.com/question/car-runs-rough) can be caused by a number of things: misfiring, dirty throttle body, injectors, fuel filter, idle air control valve and so on. There was a technical service bulletin from Ford for this engine which pointed...

Hi there. There is not much of an easier way to remove the housing. However, look at the situation and look to see what needs to be taken off and what does not need to be taken off. If oil...

It sounds like you may have a clogged catalytic converter. As you may already know, the catalytic converter converts toxic exhaust gases into less harmful pollutants that are suitable to be expelled into the atmosphere. When this is clogged, this...

Hi there. I understand your concern. You can perform an oil consumption test similar to what I have performed while employed at the Toyota/Lexus dealerships. Perform a fresh oil change. Clean everything. Note the level on the oil dipstick. Zip...

Hi There, Unfortunately, it sounds like the shift linkage (https://www.yourmechanic.com/services/shift-selector-cable-replacement) may have been broken during the tow. This can happen when the car is jammed into gear or forced from one gear to the next. The will not come out...

Your anti-theft light is blinking due to the theft system is activated and will not allow the vehicle to start. The code 16 is not something that is used by mechanics in the field but was used by engineers in...

Based on the diagrams for your car, it looks like you will need a flex pipe with slip fit ends that will accommodate 2.25 inch OD steel exhaust pipe. You can confirm that by measuring the OD of the undamaged...