Q: How do I choose the color theme?

Hello, the operation of the fuel gauge is like this. The fuel level sensor receives a steady voltage input, and as the level changes the voltage output of the fuel level sensor change. The fuel gauge in the dash receives...

You should be able to remove fuse number 20 (https://www.yourmechanic.com/services/fuse-replacement) to turn off just the trunk light. If you disconnected the trunk light switch and light still stays on then you may have a short in the instrument cluster since...

Hello. Normally, the cause of this problem is that the door lock switch is sticking or has failed completely. The door lock switch is located in the door jam, usually near the door latch. When the door lock switch gets...

You may have a broken motor or transmission mount (https://www.yourmechanic.com/services/engine-mount-replacement) that will allow the transmission or engine to move excessively. Also another possible cause is the transmission torque converter sticking when commanded to release. There are technical bulletins (https://www.yourmechanic.com/article/how-to-use-a-technical-service-bulletin-by-parker-hill) to...

Hello. It sounds like you have a gear, bearing, bushing, or other rotating component issue caused by wear. At that mileage, really the thing to do is just simply rebuild the transmission which is not particularly difficult since it is...

Hi and thanks for contacting YourMechanic. Check the fluid to the transmission, and look at the color of the transmission oil and see if it is red or dark red. If it is dark red (varnished), then change the oil...

Some of the common causes of Diagnostic Trouble Code P0340 (https://www.yourmechanic.com/article/p0340-obd-ii-trouble-code-camshaft-position-sensor-circuit-malfunction-by-jamahl-walker) include camshaft position sensor circuit wiring that is broken, shorted, or corroded; a camshaft position sensor circuit connector that is broken, shorted, or corroded; a faulty camshaft position sensor;...

Hello, thank you for writing in. When dealing with an issue with the starting system, you want start by making sure the battery is in good condition. Make sure its cables are clean, dry, and tight as well. You can...

The knock sensor is located on top of the engine beneath the intake manifold which must be removed to gain access. With regard to diagnostic trouble code P0325 (https://www.yourmechanic.com/article/p0325-obd-ii-trouble-code-knock-sensor-malfunction-sensor-1-bank-1-by-spencer-clayton) that code does not mean the knock sensor has failed. All...