Skip the auto shop - Our mechanics make house calls

Q: How do I adjust the remote start passenger seat?

asked by on

How do I adjust the remote start passenger seat?

A: When the remote start passenger seat is tur...

When the remote start passenger seat is turned on, then the front passenger seat’s seat warmers will automatically turn on when the vehicle is started via remote start. To turn this feature on or off, follow these steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Convenience is displayed, then press the OK button. 3. Press the Up/Down buttons until Remote Start is displayed, then press the OK button. 4. Press the Up/Down buttons until Climate Control is displayed, then press the OK button. 5. Press the Up/Down buttons until Passenger Seat is displayed, then press the OK button. 6. Select Auto or Off.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: How do I install a head restraint?

The front head restraints, and the rear center head restraint can be removed. After being removed, these head restraints will need to be reinstalled. Installing one of the head restraints takes only a few seconds: 1. Insert the head restraint...

Q: Drive Shaft out of balance. Negative effect

Hello, thanks for writing in about your Ford Explorer. The vibrating drive shaft can cause premature bearing failure in the rear end and the transmission tail shaft. You should take it to a driveshaft shop or have it serviced by...

Q: How do I change modes with the engine start/stop switch?

If your car is equipped with the smart key system, it means that you have a start/stop switch rather than a conventional ignition switch. This allows you to crank the engine from all positions by pressing the button (with your...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.