Skip the auto shop - Our mechanics make house calls

Q: How do I adjust the collision warning Warning Light?

asked by on

How do I adjust the collision warning Warning Light?

The collision warning system is an important safety feature that lets you know when your vehicle is in danger of a collision. The collision warning system alerts you with both a chime and a warning light, but the warning light can be turned on or off. To do so, follow these steps: 1. Press the Up/Down buttons on the steering wheel until Settings is displayed on the instrument panel, then press the OK button. 2. Press the Up/Down buttons until Driver Assist is displayed, then press the OK button. 3. Press the Up/Down buttons until Collision Warning is displayed, then press the OK button. 4. Press the Up/Down buttons until Warning is displayed, then press the OK button. 5. Select On or Off.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How to adjust the autolamp delay duration on a 2003 Ford Explorer (not equipped with the setup button)

Hello. The auto lamp delay is changed by the button on the rear view mirror. This button allows you to change the delay function. If you do not have the button on your vehicle then it cannot be changed manually....

Q: DSG transmission slipping gears 2012 VW GTI

Hello - I think you're getting the run-around. These DSG transmissions are quite sophisticated, and have very detailed on-board diagnostic capability. Check with another VW service center, which will use a VAG-COM diagnostic tool to check for problem codes with...

Q: Output shaft speed sensor 2013 Ford Mustang what will happen if I disconnected car is not running right now

Disconnecting the sensor will cause the vehicle computer to see an open circuit to the sensor and turn on the Check Engine Light. The computer may go into a failure mode and cause many different drive problems depending on the...

Related articles

What Causes Hoses to Leak?
While the largest part of your engine is mechanical, hydraulics plays a significant role. You’ll find fluids at work in a number of different areas. Your car's fluids include: Engine oil Transmission...
How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...