Q: Shifting problem?

If you plan on repairing or replacing the ignition cylinder (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-lock-cylinder) on the vehicle yourself, then I would suggest getting a service manual to do this. I may give you the directions to do it, but If I missed one...

From what you've described, it sounds like the door latch may have been jammed when the lock and handle was actuated at the same time. The door panel will have to be removed from the inside by removing the rear...

Hello. If your vehicle is losing transmission fluid and there is no noticeable leaks then it may be possible that the transmission is burning the fluid. I would check the fluid for any signs that the transmission may be burning...

The first thing to try since it is hardened is to use a hot soapy water solution. Have the water as hot as you can stand it without burning your hands. The hottest water can be poured onto the sap...

Overheating of any kind will cause the cooling system to boil, creating the bubbling in the coolant jug. All of the parts you listed can make this happen if they are not working correctly. The question is which one is...

Hello. Just a little washer fluid in your coolant system should not have any harmful effects, but it will be a good idea to flush the coolant system to keep the coolant in optimum condition and it is a great...

You should request a starter circuit diagnostic (https://www.yourmechanic.com/services/starter-replacement) to get this resolved. If you want to attempt to diagnose it yourself, first perform a load test (https://www.yourmechanic.com/services/battery-is-dead-inspection) on the battery just to be sure that the battery is not an...

Hi there. One of the common problems that comes up on these newer push button style transmission selectors is that the buttons themselves can break, or an electrical fuse or connection from the button to the transmission control module becomes...

Removing the door panel requires a set of broad flat bladed clip tools (screw drivers are too narrow and will crack the plastic). In the Factory Service Manual, there is an illustration showing where all the clips are located so...