Q: Heavy grinding when trying to start

asked by on December 10, 2016

Loud heavy grinding when turning the ignition, battery not dead

My car has 198888 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Taillight not working after bulb replacement
You may have a couple possible problems on this vehicle. The most common problem on these vehicles is the totally intergraded power control module not sending power to the rear lights as it should. Another possible problem is if you...
Computer reads an issue with the oxygen sensor on a Subaru Forester 1999 2.0 Turbo. What is the problem?
Your 1999 Subaru Forester has pre and post catalytic converter oxygen sensors. The pre-converter sensor optimizes fuel trim while the post converter sensor monitors the efficiency of the catalytic converter. A failing pre-converter sensor will degrade vehicle MPG performance. Although...
Parking lights are not working - 2009 Chevrolet Impala
The park, tail, license and marker lamps are turned on when the headlamp switch is turned on, or anytime the automatic light control turns the headlamps on. In either of these scenarios, the body control module (BCM) applies ground to...
Radiator problem
An auto parts store or online parts supplier would be the best place to find the answer for this. They can look up the radiator part numbers for both vehicles. If they have the same part number, then it should...
changed altenator, still no power going to battery
If the alternator is "new", and thus presumably good, the vehicle engine is running, the alternator drive belt is appropriately tightened, and yet you are not getting around 14.5 volts of charging current at the battery posts, that means there...
The VDC LIGHTS AND CHECK ENGINE LIGHTS LIGHT UP IN THE DASH BOARD
Hi there. Anytime you see a check engine light or other warning light illuminate on the dashboard, it is due to a fault being stored in the ECU of your Nissan. The fault code typically indicates that a system or...
ESP stability control light is on.
Hi there. If the vehicle was jolted hard on the front end when the vehicle hit a pole, then the Electronic Stability Motor may have had a harsh force applied to it causing the motor to either fail or become...
I would like to know the estimated time for an oil change ser
There is a minimum one hour service call for an oil change and just this service without any other services should take about an hour to perform. (oil change) [https://www.yourmechanic.com/services/change-oil-and-filter]

Related articles

A Buyer's Guide to the 2012 Nissan Titan
With With the 2012 Titan, Nissan continues its march into domestic territory. This model lives up to its name, but it’s also quite impressive inside as well. Even if you are in the market and wouldn’t normally consider a truck,...
The Best Used Cars to Buy If You're a Teacher
If If you are a teacher, probably foremost on your mind is getting to school on time. You would also probably like a used car that is easy on gas and not terribly expensive, and will hold your gym gear...
Symptoms of a Bad or Failing PCV Valve Hose
Common signs include poor fuel economy, the Check Engine Light coming on, engine misfires while idling, and noise from the engine.