Q: Starting when hot

Unless set otherwise, your engine will run for 10 minutes after being turned on via remote start. After 10 minutes, if the car has not been operated, the engine will turn off. You can extend the remote start time at...

Hi there. I would suspect another pulley that the serpentine belt drives has a dry/loose bearing. Have a certified mechanic, like ones from YourMechanic, inspect the noise (https://www.yourmechanic.com/services/loud-squealing-or-squeaking-is-coming-from-timing-belt-inspection) and check each pulley for play.

Hello and thank you for contacting Your Mechanic. The code P0760 (https://www.yourmechanic.com/article/p0760-obd-ii-trouble-code-shift-solenoid-c-malfunction-by-valerie-johnston) means that the shift solenoid "C" is operating irregularity. The code P0870 means that the transmission fluid pressure is not determined at its specified pressure. Check the harness...

This is likely a compressor issue. The compressor may be faulty or may have a bad connection. This can be tested several ways. You may have a code available from the computer which explains more about the compressor issue. You...

Hi there. Check the battery cables to see if they are loose and if there is any corrosion. Check the condition of wires to the starter to ensure that they are tight and there is no corrosion. If the battery...

Hello. There are any number of reasons that would cause your car to go into limp mode. Anything that the computer sees that can cause damage to the power train will put the vehicle into limp mode. I would need...

Hello - I believe the serpentine belt (https://www.yourmechanic.com/article/how-long-does-a-serpentine-drive-belt-last), which drives the alternator, power steering pump, and water pump, failed. This caused all of the symptoms you describe. I recommend a serpentine belt replacement (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement) performed by a mobile, professional mechanic,...

The knock sensor is the most likely cause of the P0326 trouble code. It is also possible that the wiring that goes to the knock sensor could have an issue but this is unlikely. The P0420 code is likely due...

It sounds like you may have a problem with one or more cylinders misfiring. Engine misfires (https://www.yourmechanic.com/services/engine-is-misfiring-inspection) can be caused by many different problems and are generally caused by either a spark or fuel issue or in some cases, a...