Q: Have changed brake pads, have bled the lines 4 times now but having to press brake to the floor to get car to stop. What is wrong?

When we are discussing ABS systems it is good to note the year and make of your vehicle because ABS systems have evolved quite a bit over the years, but you also have to know how the ABS system works....

This could be a serious issue and needs to be looked at immediately. It is possible a fuel leak has developed in the fuel supply or return line. This leaking fuel could be ignited and fire could result. The entire...

This vehicle has many technical bulletins that pertains to wiring issues with pins and connectors to various modules and control units in the vehicle. This issue is one that is hard to track down since it is an intermittent connection...

You replaced the accelerator pedal and the throttle body itself. The throttle position sensor (TPS) is a sensor that is located on the throttle body used to monitor the throttle position of the throttle plate inside the throttle body in...

Hi there - it's possible that your problem source is the torque converter lockup clutch (https://www.yourmechanic.com/question/car-hesitates-and-then-jerks-to-go-into-first-gear-by-brenda) NOT releasing as the truck slows down. This would lug the engine as though it's in top gear until vibration, or an engine stop/start...

Hi there. I have forwarded your request to our sales department. The Q & A is intended for mechanical repair and service tips. One of our sales professionals will reply to you soon. Thank you!

Hi there. Unfortunately, our mobile mechanics do not complete engine replacement services; as it should be completed in a shop with the correct equipment to complete this job correctly. Depending on where you live, there might be a few engine...

There are a number of things that may cause the car to hesitate (https://www.yourmechanic.com/services/engine-hesitates-during-acceleration-inspection) when accelerating such as low fuel pressure, a dirty or faulty mass air flow sensor, clogged or dirty fuel injectors, a faulty throttle position sensor or...

You cannot go too wide more than an inch or it will rub the fenders on the car. Look at the tires you have now in rear and see how close to fender the tire is and see how much...