Q: Had Walmart install two new batteries In my truck, they also replaced to terminal post cable ends. Brought truck home and try to

asked by on December 01, 2017

I had Walmart install two new batteries on my truck, they also replaced two of the four terminal post ends due to corrosion. I brought the truck home and tried to crank a few hours later and all I get is one big click noise. No cranking. I am assuming the starter/selonoid

My car has 601000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do you attach a child seat tether to the upper anchor?
If you’re using a child seat that features a tether, it should be secured to the anchor point above the rear seat in the car. Here’s how to attach it: Pull the tether out and up to the top of...
Green light flashing around D4 indicator
When your transmission D4 light is blinking, this means your transmission has stored a code. The code would need to be retrieved and diagnosed to see what the problem is. These transmissions were pretty reliable, but had problems with the...
Trans shifts when cold gets stuck in 2nd when temp hits about 210
Hello. A transmission that gets stuck in 2nd gear can be caused by a few things. A few possible causes are, as you suspected, a faulty speed sensor (https://www.yourmechanic.com/services/speed-sensor-replacement), a faulty shift solenoid, or even a mechanical issue. The speed...
How do I change trip odometer stats
Hi there. To change the trip status (https://www.yourmechanic.com/article/4-essential-things-to-know-about-your-car-s-odometer) on the dash, press the DISP button on the steering wheel until the dash reads the trip messages. Then, you can cycle through the trip status on the dash and see what...
I changed my mas and the check engine light came back on what next
You will need to have the computer scanned to see why the light came back on. If you continue to get codes to the mass air sensor then you should have the pinpoint test completed that will test the system...
How do you reset a IAC valve in a 97 Jeep Grand Cherokee?
Make sure the engine is at operating temperature. Then you need to set the idle stop on the throttle body to the lowest setting, unless it is already there. Then to fully extend the IAC, jumper ALDL pins A and...
Carb problems, if I blow air into the fuel intake, with the float needle held shut, should any air pass thru?
That is correct. There should be no air going through the fuel intake with the float held closed.
i just bought a 2014 Malibu LTZ, the diller replaced the trunk battery, and said they reset the code, but after driving 3 blocks,
A lot of times a code is an indication of a problem and the mechanic will replace the most common cause of the problem without properly diagnosing the actual code. In order to assist you better you will need to...

Related articles

2012 Nissan Rogue vs. 2012 Ford Escape: Which One Should I Buy?
Sport Utility Vehicles (SUVs) use the chassis of a truck to provide superior structure, with a larger size and often poor gas mileage. While that isn’t always true, SUVs have a raised ground clearance and are generally meant to haul...
The Best Used Cars to Buy If You're an Uber or Lyft Driver
Are Are you thinking of becoming a driver for Uber or Lyft? That could be an exciting career change – you’ll get to meet a lot of interesting people, and if you love to drive, what better way to spend...
The Best Used Cars to Buy If You Love Road Trips
If If you love to travel, comfort is very important in a vehicle. You want a nice, quiet ride, comfortable seating, and enough room. We have evaluated several used vehicles, and narrowed our favorite road trip vehicles down to the...