Q: Gear shifter spring popped off

First thing you'd want to do, if you haven't already, is to change the fuel filter (https://www.yourmechanic.com/services/fuel-filter-replacement). If you did, you'd want to check the catalytic converter (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-catalytic-converter), because when the catalytic converter starts to clog up, it can't exit...

Hello. The amplifier draw for your air conditioning compressor should be between 10amp-20amp. I do not believe that there are shims in the clutch plate. The best thing to do would be to purchase a Chilton manual for your van....

This issue is normally caused by low fuel pressure or a faulty injector, but since you have just replaced the fuel pump, this may also be a sign of a failing idle air control (IAC) valve. This is a unit...

Hello. If you've already cleaned the sensors with soap and water then you probably won't need to clean them again with stronger chemicals. The ABS sensors function as magnetic type sensors, and only need to be clean and free of...

If you are using less than a quart of oil for every 1000 miles then this is normal. If you are using more than a quart for every 750 miles then you may have an issue but you will need...

Hi there. Check the thermostat on the air conditioning system and see if its freezing up again by shutting off the vehicle and letting it sit for about 30 minutes. If you see frost on the evaporator, then the system...

Hi - yes, you are correct. This error code (P0340 (https://www.yourmechanic.com/article/p0340-obd-ii-trouble-code-camshaft-position-sensor-circuit-malfunction-by-jamahl-walker)) means either the sensor, or the wiring and connectors for this sensor, are malfunctioning. Check the wiring connection for the sensor first, but most likely, the sensor has failed....

Hi there. Usually there are some good videos on YouTube.com that show how to complete this step, but after searching; I've not found any for your particular vehicle. Typically, the owner manual inside your glove box will give you detailed...

The serpentine belt can break simply because it has reached the end of its service life. Another cause of breakage is if one of the driven rotating elements seizes. That would cause the belt to suddenly stop on that element...