Q: Engine noise

The Econ mode indicator is located on the instrument panel. When the indicator is illuminated, it means that the vehicle is currently in Econ mode. When Econ mode is turned off, the light will go away. Tip The Econ mode...

Hey there, thanks for writing in about your 2013 BMW 650i. Solutions have been found to problems similar to yours, but two vehicles with the same symptoms may still require different repairs. Your best bet is to have an experienced...

Headlight covers (https://www.yourmechanic.com/article/how-to-add-headlight-covers-by-jason-unrau) are legal, as long as the amount of light that gets through meets state requirements. Each state has its own requirements, so you will need to contact your state police or highway patrol to know for sure....

I wouldn't assume that the rear converter is bad unless the mechanic actually performed a diagnostic on the converter AND then explained to you what was done, what was found and WHY the solution is to replace the converter. If...

Hi there. Rust proofing your vehicle is very important to prevent your vehicle from rusting or corroding. I recommend getting the free roof rust proofing for your vehicle. The dealership is advertising this for you to come in and get...

Hi there - the valve body (https://www.yourmechanic.com/article/does-an-automatic-transmission-have-a-clutch) on this transmission is prone to wear, especially for control pressure hydraulic circuits on high-mileage units like yours. If you did not replace the valve body with a rebuilt unit, and the control...

Hi There, It sounds like you are describing the symptoms of a failing throttle position sensor. The throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement) monitors the throttle position of the throttle plate inside the throttle body in relation to your foot position on...

There can be several codes pertaining to the camshaft sensor and you did not supply the code you are getting. You may be having a problem with the camshaft timing phaser not being in the correct position when engine is...

Hi Rebecca. Thanks for reaching out to us tonight. When a vehicle stalls and loses electrical power like you've described, it can be very tricky to diagnose, since there are so many possible sources. In many cases, this can be...