Q: Engine light is on and code is evaporative emissions system vent control circuit for 1998 Camry it also has a hard time starting

While you can add phonebooks and even transfer individual numbers to your car’s phonebook, you’ll find that dialing frequently called numbers is sort of a hassle with this method. To make things easier, you can use the speed dial system....

The problem you describe can be the crankshaft position sensor. The sensor is a major failure on these vehicles and can cause no starts or intermittent starts and stalls. Have a qualified mechanic test you car with an approved scanner...

For modern cars, a lot of them are pretty particular on what fluid they use. If you just add the fluid in the mix, it may not be compatible with the fluid that's in your transmission. If your transmission is...

Hi there. Sounds like the heater core has a leak and needs replaced. I recommend removing the heater core hoses to the heater core on the firewall in the engine compartment and routing the hoses together until you replace the...

Hello. I would need to know what kind of vehicle this is to be able to give you the best possible information. If the key was installed wrong and will not come out of the ignition then most of the...

Hi There, What you are describing is a common problem with a dirty or faulty mass air flow sensor. The mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) monitors air intake as it is mixed with fuel prior to being injected into the...

A failed head gasket could account for both the overheating and the oil leak but that is pure speculation as the overheating and the oil leak could also be totally unrelated. If you request an engine overheating diagnostic (https://www.yourmechanic.com/services/car-is-overheating-inspection) the...

Yes, firmware, the BCM (body control module), temperature outputs, the harness, faulty batteries, could all be potential causes of this sort of intermittent fault. The problem you having is probably not common though because I do not see a pattern...

There are a number of things that may cause a rough idle. A rough idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) may be caused by things such as low fuel pressure, low voltage to the fuel injectors, dirty fuel injectors, a vacuum leak, a faulty...