Q: Check engine light

asked by on January 28, 2017

My engine light came on I stopped and added oil then engine light came on should I be worried? Or is it going to come off

My car has 93000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Sunroof won't close
I would recommend having your sunroof inspected (https://www.yourmechanic.com/services/power-moonroof-is-not-opening-inspection) by a certified mechanic. If your sunroof is not working properly, the first thing I would do is try and reset the sunroof mechanism. This can be done by either unplugging the...
Engine rattling, shaking and loss of power
The VANOS unit or solenoid can cause a rattling sound from the engine. The VANOS is a camshaft timing system which runs off of engine oil pressure. If the oil is the wrong viscosity or the system has a buildup...
Truck won't run like it used to
Hi, thanks for writing in. Believe it or not, this happens quite a bit when people swap OEM air filters to K&N or other products. It has nothing to do with the aftermarket part however. The P-0104 OBD-II error code...
cranks but wont start
There may be a downloadable diagnostic trouble code(s) (from the PCM) so I recommend that you request a no start diagnostic (https://www.yourmechanic.com/services/car-is-not-starting-inspection) to first see if there is a quick and ready indication of the problem and thence a solution....
My car is overheating it does not have any oil and also it won't start or crank at all what could be the problem?
Hello, thank you for writing in. The engine may be in a protective shut down mode that wont let it start, or it may be seized. It is hard to tell based on the given information. You will want to...
Transmission
For this 2004 year Mercury Mountaineer they were only equipped with a 5R55S transmission for the 4.0 and 4.6 liter motors. The only different transmissions would be for rear wheel drive or all wheel drive. They are both 5R55S base...
WHITE SMOKE COMING FROM ENGINE BUT NOT OVERHEATING
Hi there. If smoke is coming from the back of the engine, it's possible that you have a small coolant leak, oil leak or even windshield wiper fluid leak. Smoke can also come from an electrical system malfunction, serpentine or...
Car want start unless boosted, alternator good and battery good, while boosted the car crank in the key off position.
You should request a starter circuit diagnostic (https://www.yourmechanic.com/services/starter-replacement) to get this resolved. If you want to attempt to diagnose it yourself, first perform a load test (https://www.yourmechanic.com/services/battery-is-dead-inspection) on the battery just to be sure that the battery is not an...
Hi I have a 2012 Subaru Impreza when I got in the car this morning the check engine light was on every light was on blinking so I
Exhaust leaks are a high priority to fix due to the dangers of carbon monoxide. Also, dependent on leak location, exhaust leaks can throw off the proper operation of otherwise good oxygen sensors. To request identification of where the exhaust...

Related articles

Symptoms of a Bad or Failing Thermo Coolant Fan Switch
Common signs include engine overheating, the Check Engine Light coming on, and a broken or shorter signal wire.
P0017 OBD-II Trouble Code: Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B)
P0017 P0017 code definition Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor B) What the P0017 code means P0017 is the OBD-II generic code indicating that the crankshaft and camshaft position sensor for bank 1 exhaust camshaft do not...
P0391 OBD-II Trouble Code: Camshaft Position Sensor "B" Circuit Range/Performance (Bank 2)
P0391 code means indicates that the problem is on the side of the engine which does not contain cylinder #1 due to bad sensors, or connectors.