Q: engine and gearbox connection

asked by on

how is the engine and gear box connected after repair my mechanic is stuck
My car has an automatic transmission.

I would recommend that they get a subscription to AllDataDIY to look up the factory service procedure. They are connected via multiple bolts around the perimeter of the transmission and torque converter bolts connecting to the flywheel. If you would like to have the gearbox installed for you by another mechanic, a technician from YourMechanic can come to your car’s location to perform this service.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. engine and gearbox connection

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: What all needs replaced when you change a camshaft position sensor? 2003 Hyundai Sonata

Hello - only the camshaft position sensor needs replacing. Sent to CS camshaft position sensor replacement

Q: I. Have a. Sonata 2011. It accelerate. But dont adcance went im driving it it gave me a throttle body code

The throttle body trouble code may be a key clue but the components, system and wiring referred to in the trouble code have to be individually diagnosed (the code itself is not a diagnostic or "result", but rather the code...

Q: Whining noise from the 4 cyl engine.

If you are hearing the noise at idle when the car is not moving, generally the noise you are describing originates in the engine, the transmission (torque converter runs even at idle), and/or the accessory drives. However, if there is...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.