Q: Driving home noticed my heat was blowing cold, I turned the fan down and car started to overheat, I then turned the fan back on an

While AM and FM stations are free to listen to, satellite radio (SIRIUS) is a paid service. In order to receive signal after the initial trial period is over, you’ll need to enroll with SIRIUS Radio. To do that, you’ll...

It sounds like the fuel gauge is stuck in the e position. There is a common fix for this problem. You need to get some rare earth metal magnets, made of neodymium, and place them near the fuel gauge, and...

The clutch hydraulic system would have to be checked first, to make sure it is moving the clutch pressure plate. If it is working properly, then your clutch pressure plate has a problem, and the transmission would need to come...

Hi there, the Corolla has a timing chain that won't make a squealing sound because there are splines on the inside of the belt/chain to prevent slipping. There are tensioners and pulleys that can wear out over time causing unwanted...

If your vehicle is equipped with a sun roof, then you may have a water leak due to the drains for the roof on both sides being blocked with dirt and debris. You may also have a blocked A/C drain...

Hi there. Today's synthetic oils are much different than in years past, so accidental mixing like you've described is not as damaging to the engine as in years past. However, I would recommend having the oil changed (https://www.yourmechanic.com/services/change-oil-and-filter) sooner rather...

The most common cause of the engine crank no start (https://www.yourmechanic.com/services/car-is-not-starting-inspection) is loss of ignition spark from the ignition system. The distributor is known to have internal shaft oil leaks that will short out the internal cam and crankshaft sensors...

Hi there. The issue with leaving bolts in the bell housing on the transmission will be come catastrophic when the bolts come in contact with the clutch assembly. I recommend removing the starter and taking a telescoping magnet through the...

P0011 (https://www.yourmechanic.com/article/p0011-obd-ii-trouble-code-camshaft-position-a-timing-over-advanced-or-system-performance-bank-1-by-jay-safford) means that the intake camshaft is more advanced than what the ECM has commanded. Typically, the mechanic would resolve this by checking the electrical connectors, wiring, or valve issues for the camshaft oil control valve for the engine's...