Q: Didn't want to start then started drove 40 mi overheat a little at red light car die wont start

asked by on September 20, 2017

Drove to work no probelm time to come home car didnt want to start sounding like out of gas. Have gas that not the problem. Finally started like 2 to 3 min later drove 40 mi started overheating a little stop at a red light car die wont start back up. Someone told me started went out but I was driving

My car has 2000000 miles.
My car's transmission is unknown to me.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I use the engine block heater in a 2012 Dodge Ram?
The engine block heater helps heat up your engine during very cold weather. If your vehicle has the engine block heater, you should always use it when starting your car in extremely cold conditions. Here’s how. Locate the engine block...
Sunroof broken.
Sometimes the seal around the sunroof sticks and if you give it a little push thats all it needs to overcome that binding, other times the switch or motor has failed but the fuse should always be checked first. Have...
Vibration when changing gears.
Vibration between shifts in an automatic or manual are pretty similar and are usually caused by loose motor or transmission mounts, but could be mimicked by suspension components. Have a mechanic from YourMechanic inspect your vehicle (https://www.yourmechanic.com/services/car-is-shaking-or-vibrating-inspection) for any looseness...
Clutch problem
Hi. Clutch problems are not limited to the disc wearing out. Pressure plate, throw out bearing or hydraulic system issues could also be at fault depending on the type of problem you are having. If the clutch is slipping, then...
Car dies
There could be quite a few things that can cause this. Reading out faults from the engine computer will be key to guiding the diagnosis in the right direction. Depending on when the stalling occurs -- at idle, part load,...
Getting error codes P0599 and P0171. Ive cleaned the O2 sensors but have no idea where to go from here.
Hello. Code P0599 is the code for an issue with the thermostat heater control circuit, while P0171 is for a lean condition on bank 1. P0599 is set when the computer detects that there is an issue with the electronically...
Does not always work. Can play with ignition and sometimes will work.
If your ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement) is malfunctioning, I would recommend having it tested and replaced if necessary. It is important to have this job performed professionally to avoid any potential mistakes. Sometimes ignition switches have many small pieces called tumblers...
How do I know if it's my blower motor resistor or the resistor switch that's not working?
The referenced parts are tested with an ohmmeter. The resistor block (https://www.yourmechanic.com/services/heater-blower-motor-resistor-replacement) must have a specified resistance across each element on the block. However, if any resistors are open (infinite resistance), the block is just condemned and replaced automatically. Occasionally,...

Related articles

A Buyer’s Guide to the 2012 Kia Sportage
The The 2012 Kia Sportage is a compact Sub that offers quality, reliability, and great fuel economy. It has lots of nice features that come standard, an available turbocharged engine, and a sleek looking style that make it attractive to...
A Buyer’s Guide to the 2012 Kia Optima Hybrid
Kia Kia has really turned over a new leaf with their cars in the past few years, and the 2012 Kia Optima Hybrid is certainly no exception. With the same attractive design as the Optima, higher fuel efficiency, and a...
Symptoms of a Bad or Failing Electronic Ignition Pickup
If your car has an electronic distributor ignition system and the engine stalls or car does not start, you may have to replace the ignition pickup.