Q: Cylinder misfire on 1 and 10 on a 2007 7060L. Replaced plugs and coil on both. Can just the two injectors be replaced to get rid o

When your vehicle's engine will not turn over or the Battery Light (https://www.yourmechanic.com/services/battery-light-is-on-inspection) comes on in the dash, how do you know if it is caused by a defective battery or alternator? This article will help explain how each component...

Hello there, thank you for asking about your 2003 Land Rover Freelander. If the car goes into reverse, but does not move, this suggests a faulty clutch pack problem in your transmission. This may also suggest potentially a faulty transmission...

Hello. If this is occurring right after you get fuel then most of the time it is caused by a vent valve or purge valve that is sticking open. Most of the time it is a purge valve problem. This...

This may be an issue of a faulty ABS control module or possibly faulty wheel sensors. This is a unit that controls the activation of the ABS system based upon inputs from the ABS wheel sensors. When this module is...

The serpentine belt need constant tension on the belt to keep it from coming off. If the belt alignment is not aligned then the belt may come off. The tensioner may be out of alignment and not putting enough tension...

Hi There, When the engine is running too lean this means that there is not enough fuel getting to the combustion chamber to be ignited as the engine runs. This can cause many different problems such as the engine stalling...

Billing question sent to CS for the cost to diagnose and repair a possible burned valve on a 2008 Jeep Commander with a V6-3.7L engine.

Hello, thank you for writing in. The issue is very likely a fault with the wiper switch. While there can be some electrical testing done to verify this, the switches are known to go bad after being used for that...

It sounds like the caliper brackets may have been misaligned when replaced. Some brake calipers are designed to "float" meaning they will slide along a small path to allow for movement in the wheels when changing gears or shifting movement...