Q: Cost to replace O2 sensors and belts on 2003 Acura MDX

If the clutch pedal goes down without engaging the clutch. The fluid level needs to be checked in the clutch reservoir. If the level is good then there is a bad seal on either the master or slave cylinder. If...

A misfire will generally cause a rough idle, (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) but you must find out if its one cylinder misfiring or a random misfire, this is were a scan tool is essential. If you can trace the misfire to one cylinder...

Hello. There are many possible recalls (https://www.yourmechanic.com/article/how-to-check-if-your-car-has-recalls) for steering, safety belts, transmission, radio, computer reprogramming and seats power recliner issues. There may be ever more problems that the dealer has listed and not published yet. The vehicle had more recalls...

Hello. A rattling noise during turns can be caused by many things. If you suspect the noise sounds like a pebble rattle it may be possible that there is one stuck somewhere, perhaps in between the vehicle's wheel well covers,...

Hi and thanks for contacting YourMechanic. Check the battery cables (https://www.yourmechanic.com/services/battery-cable-replacement) for more corrosion and clean them up again (https://www.yourmechanic.com/article/how-to-clean-battery-terminal-connections-on-a-car). You may need to put backing soda and water mixture on the terminals to clean the corrosion completely off. Make...

Be sure you have a fully charged battery that passes a load test (https://www.yourmechanic.com/services/battery-is-dead-inspection). With a fully charged battery, if the starter motor does not run that signifies an electrical problem in the starter circuit or a problem with the...

Hello - this problem can be diagnosed by connecting an ammeter to the positive (red) battery cable, observe the current drain (likely less than 1 amp), then, one at a time, remove each fuse, check to see if the current...

The issue is that the fuel pump is starting to wear out and not turn on when either the fuel pump relay is hot or the fuel pump is shorting out internally. Check the fuel pump relay when the engine...

Hi Jimmy. Thanks for contacting us today. I'm in agreement with you - in that the replacement of engine mounts is NOT a solution to resolve a P-0420 Error Code. You should read this article about this code (https://www.yourmechanic.com/article/p0420-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-1-by-jamahl-walker) -...