Q: Cost of disc brake, pad front and rear.also, rotors brake shoes and pads. Belt serpentine

Hi there. The power steering system on your Hyundai is ran by a hydraulic pump. Most of the time if there is a loud noise coming from the pump it is because the fluid is low. I would start by...

Hi. An engine replacement in your vehicle will cost between $2,000 and $4,000. This Depends on where the engine is installed and where the replacement engine is ordered from. The engine itself can range from $500 to $2,000. The labor...

Hello there, thank you for asking about your 2005 Jeep Liberty. This is typically a common symptom of a failing idle air control valve, which is a unit that monitors the air intake as it is mixed with the fuel...

Hi, thanks for writing in. This may be likely related to a faulty mass airflow sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-mass-airflow-sensor) which is a unit that regulates air intake (https://www.yourmechanic.com/article/what-does-the-mass-airflow-sensor-do) as it is mixed with fuel. When this is faulty, it can cause an...

Hi there: It is very possible that the battery might be fully charged, but be lacking cold cranking amps. As a battery ages, the cells inside will begin to wear out, causing a reduction in the amount of 'cold cranking...

The stalling you are describing probably stems from a fuel and/or ignition system fault although air induction could be an issue including the possibility of a large vacuum leak from, for example, a leaking brake booster. To see if it's...

Hi there - there are several possible cause for over-retarded cam timing (https://www.yourmechanic.com/article/p0012-obd-ii-trouble-code-camshaft-position-a-timing-over-retarded-bank-1-by-jay-safford). The VCT solenoid could cause this, but a failed cam phaser, worn timing chain guide, stretched timing chain or simply low oil pressure can also cause this...

The time depends on whether you are dropping in a pre-assembled (re-built or used) axle/differential or are talking about re-building what you have. To just remove and re-install the entire assembly would require roughly 7 to 11 hours depending on...

There are a number of ways to resolve this issue. The first of which is to trace the wire until you find the other end and replace the wire with the OEM part. You could also try to simply attatch...