Q: Checking for answers

You can customize the audio controls to make the sound system ideal for your ears. The controls that you can personalize are Bass, Treble, Balance, and Fade. Adjusting these controls only takes a few seconds: 1. Press the Setup button....

First off, you need a working thermostat in the car for it to function properly. If you removed the thermostat (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-thermostat) to fix an overheating problem, you will need to install a new one and begin the process of diagnosing...

When you operate the driver's window switch, if you hear the motor run in both directions, then the window regulator (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-window-motor-regulator-assembly) is most likely broken. The window regulator may require the motor and regulator together depending on part availability. If...

Hello. The fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) on your vehicle is powered through the fuel pump relay (https://www.yourmechanic.com/services/fuel-pump-relay-replacement) through direct battery power. The fuel pump itself is located in the fuel tank and there is not an access panel to easily change...

Hello. I will be glad to help you with your Murano. A common cause of a "no cooling" condition is the system is low on refrigerant, however, inasmuch as your car is only 6 years old, if the refrigerant level...

Hello. It sounds like you have an issue with the suspension of the vehicle. Most of the time when this occurs it is caused by worn out suspension bushings or ball joints. These areas move and flex when going over...

If you plugged in the actuator before installing it then you have ruined the new one and need to replace it then install it before you connect the electrical connector. The system will then relearn the positions.

check the front bulbs also since they are on the same parking light fuse circuit. One of the bulbs may be bad.

Based on the information you provided, there is no obvious connection between the starting circuit fault and the noise that occurs in reverse. Unless the issue is wheel bearing, brake, or axle related your supposition about the noise being from...