Q: Car starts shaky or won't turn over

asked by on February 05, 2016

The car starts very shaky, and it sometimes wont turnover. The RPMs jump high when driving slow, and I hear a slight grinding/rattling noise.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I program MyKey?
The MyKey feature can be programmed to restrict certain driving functions. Functions like max speed max volume promote safe driving. To program MyKey. Press the Setup button until you see “Reset for MyKey Settings.” Press the Reset button. Press the...
3.7 engine temperature gauge runs between middle to 3/4, leans a little more to 3 /4 never over is this normal
Hi there, thanks for writing in about your 2007 Hummer H3. The temperature should typically rest more towards the middle of the gauge. You should have the vehicle tested to see if the engine is running hot, or if it...
Car shudder, tire noise, engine clicking - 2006 Lincoln Zephyr
It sounds like there are worn suspension bushings in the front suspension. When braking, the front suspension is subject to large stresses which accentuates a worn or damaged bushing. The "jerking" sensation you observe when braking sounds like a severely...
My Speed Sensor is not working-
Sensors are made of plastic and plastic doesn't like to be warmed and cooled. Which is exactly what is happening you your car everyday. Normally, plastics will last a 100,000 miles or so. With a new sensor, it is not...
How much would it cost to put a 6.1 or 6.4 hemi in my truck? 2001 RAM 1500
Hi there - unfortunately, this is not a service YourMechanic can offer at this time. Thanks for thinking of us however!
In my 2016 Nissan Altima, what are the fuel lines that run underneath the car under driver's side.
Hello. You will have two brake lines, a pressurized fuel line, and an evaporative emissions line. The smaller metal lines are the brake fluid lines and the other are fuel system lines.
Transmission leak and no acceleration what could be the problem?
It is possible that your transmission could be slipping due to the fluid leak. I would recommend having a transmission inspected by a qualified professional to determine the exact source of the leak. Once the leak source is determined and...
My Chevy Malibu 2013 while driving and I came to a complete stop in the car started to shake really bad and then shut off and then
Sudden loss of engine power, and then a non-functioning starter, raises the possibility of no oil in the engine. In particular, if the engine was seized, the starter would not work in any attempt to re-start the engine. But there...
2010 Chevy Traverse starting
If the starter is failing to disengage, that is typically a starter or starter circuit problem. The status the battery would be irrelevant and if the mechanic claims an "overcharged" battery is causing the starter to "run on", I would...

Related articles

How to Buy a Good Quality Alternator
The The alternator is one of those parts that, when it malfunctions, can leave you high and dry by the side of the road. This essential component of your vehicle’s systems turns mechanical energy into electrical energy, which in turn,...
How to Buy Good Quality Transfer Case Fluid
Do Do you drive an all-wheel drive, or four-wheel drive vehicle? If so, you can bet it most likely has transfer case fluid. The transfer case fluid is found within the transfer fluid case. This case can sometimes be called...
How Long Does a Transmission Position Sensor (Switch) Last?
All All automatic transmission vehicles have a safety switch in place that only allows them to start if they are in park or neutral gars. The transmission position sensor, also called the transmission position switch, ensures the vehicle is in...