Skip the auto shop - Our mechanics make house calls

Q: Car problem

asked by on

There's this hose on my car that makes my gas drop n my car won't turn on for that reason . So if I put the hose back it will turn on. Then I have to put gas back on .
My car has an automatic transmission.

Your car has a small purge valve that controls the venting of fumes from the fuel tank as these fumes build up inside, particularly when you are refueling the car with gas. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores the fuel vapors in the charcoal canister. The charcoal canister is filled with activated carbon pellets that can absorb the fuel vapors. When the engine is running, the fuel vapors are purged from the canister and burned in the engine. The vent control valve (solenoid) controls the flow of outside air in and out of the charcoal canister. The vent valve is controlled by the engine computer (PCM). Normally the vent valve is open. It closes when the engine computer tests the EVAP system for leaks. If a leak in the EVAP system is detected, the Check Engine light will illuminate on the dash and the trouble code related to the problem will be stored in the engine computer. When an air leak is present in the EVAP system, the MAP sensor will not be able to determine the air density, and the MAF sensor will not be able to determine the volume of air, entering the engine correctly. This will lead to an over fueling situation or an under fueling situation depending on the size of the air leak and engine operating speeds and load. This may eventually lead to catalytic converter problems as well as misfiring problems. I would recommend having an expert from Your Mechanic come to your home to take a look at your car to diagnose your EVAP purge solenoid.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: The crankshaft sensor blows when car is put in reverse.

The problem is going to be caused by a short in the harness that goes down to the crankshaft sensor. Check to see if the motor and transmission mounts are broken allowing the engine to move too far and hitting...

Q: I have a Chevy Colorado. DTC P0717. No input from trans input speed sensor. Need to know the circuit test procedure and sensor rep

Hello, I have provided a link below that will help you with your issue, if you click here

Q: Is my AC compressor good or bad?

You must have a massive leak in the system if you put in two cans and still nothing registers on the gauges. The entire system should be full if you put in two cans. For this issue I would suggest...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...